Driveshaft shop in Auckland?

User avatar
turoa
Pyro Junior
Posts: 3093
Joined: Sun Oct 30, 2005 12:00 pm
Location: Dorkland
Contact:

Driveshaft shop in Auckland?

Postby turoa » Wed Jan 11, 2017 9:27 am

Hi all,

I have recently swapped a 3.9 and auto into my 110 land Rover. Given that it had the Lt77 attached to a ld28 the rear driveshaft was too short with the new combo (front is standard disco item). I am now looking for a reasonably priced engineering shop in Auckland to rebuild the shaft.

In an effort to get it moving I made one the correct length out of a disco and my 110 item but given that it was a temporary one made on the floor it is not completely straight.

Can anyone recommend someone reasonably priced to either cut and straighten my shaft or retube the whole thing?

User avatar
mudlva
Hard Yaka
Posts: 2901
Joined: Mon Apr 16, 2007 12:00 pm
Location: fixing another cv!! dam lockers (Papakura)

Re: Driveshaft shop in Auckland?

Postby mudlva » Wed Jan 11, 2017 6:58 pm

Drive shaft specialist

Russell
092731532

32 Andromeda Cres
East Tamaki
Auckland
New Zealand

Been doing my d.s. for years good job and good prices compaired to betties

User avatar
turoa
Pyro Junior
Posts: 3093
Joined: Sun Oct 30, 2005 12:00 pm
Location: Dorkland
Contact:

Re: Driveshaft shop in Auckland?

Postby turoa » Thu Jan 12, 2017 12:16 pm

Awesome cheers will give him a bell!

User avatar
DieselBoy
Hard Yaka
Posts: 4562
Joined: Sun Nov 14, 2004 12:00 pm

Re: Driveshaft shop in Auckland?

Postby DieselBoy » Thu Jan 12, 2017 7:25 pm

I've had a few shafts made for the Sals to disco axle swap at ATL in Hamilton if that's any help ;)

http://www.atlbalancing.co.nz
lax2wlg wrote:Is that like saying 'she's hot, for a crackwhore??

User avatar
lilpigzuk
Tiger Balm
Posts: 2310
Joined: Mon Dec 09, 2002 12:00 pm
Location: Counties

Re: Driveshaft shop in Auckland?

Postby lilpigzuk » Thu Jan 12, 2017 9:21 pm

you sure there isn't a factory length? Let me know and I will go through the shelf. you wouldn't of had the measurement the other day!

User avatar
turoa
Pyro Junior
Posts: 3093
Joined: Sun Oct 30, 2005 12:00 pm
Location: Dorkland
Contact:

Re: Driveshaft shop in Auckland?

Postby turoa » Fri Jan 13, 2017 7:34 am

DieselBoy wrote:I've had a few shafts made for the Sals to disco axle swap at ATL in Hamilton if that's any help ;)

http://www.atlbalancing.co.nz


Cheers man, Ill give them a bell as well

lilpigzuk wrote:you sure there isn't a factory length? Let me know and I will go through the shelf. you wouldn't of had the measurement the other day!


Yep LT85 110 should have the correct shaft. Will flick you a message 8)

Return to “Drivetrain / Suspension”

Who is online

Users browsing this forum: No registered users and 2 guests