WTB: KZN130 3 or 4" panhard rod drop bracket!
WTB: KZN130 3 or 4" panhard rod drop bracket!
As per title. New or 2nd hand (excellent condition). In Aucks can pay shipping as it'll be cheap. Ta.
Last edited by bronx89 on Wed Feb 20, 2013 3:52 pm, edited 1 time in total.
- mike
- Last minute Mike
- Posts: 3543
- Joined: Fri Dec 06, 2002 12:00 pm
- Location: Christchurch - The place I'd like to be
- Contact:
Re: WTB: KZN130 2 or 3" panhard rod drop bracket!
dam, ill jump on the bandwagon for this as well, guess I need one now that I'm getting the surf done all "proper"
so make that x2, but bronx was first inline if there is only one floating around.
so make that x2, but bronx was first inline if there is only one floating around.
1973 SWB Land Rover V8 Hybrid
1994 Toyota Surf
1994 Toyota Surf
Re: WTB: KZN130 2 or 3" panhard rod drop bracket!
Haha sweet as.
How much do these usually go for? I've just found a place overseas that does them for about $120-130NZD incl. shipping. Would prefer cheap 2nd hand though funds are a bit tight at the mo!
How much do these usually go for? I've just found a place overseas that does them for about $120-130NZD incl. shipping. Would prefer cheap 2nd hand though funds are a bit tight at the mo!
- jonossiksilvia
- Hard Yaka
- Posts: 727
- Joined: Mon Jul 12, 2010 5:53 pm
- Location: christchurch
Re: WTB: KZN130 2 or 3" panhard rod drop bracket!
Get hold of Tomsoffroad. He made mine for me 3'
Current 4wd: Surf Kzn185 ssrg factory Intercooled (yet to start build)
Past 4wd: toyota surf ln130, coil sas, 1uz v8 build
Past 4wd: toyota surf ln130, coil sas, 1uz v8 build
Re: WTB: KZN130 3 or 4" panhard rod drop bracket!
For how much? Yea I'll need a 3 or 4" one as I've got a 3" susp lift. I think he quoted me about $230...
- jonossiksilvia
- Hard Yaka
- Posts: 727
- Joined: Mon Jul 12, 2010 5:53 pm
- Location: christchurch
Re: WTB: KZN130 3 or 4" panhard rod drop bracket!
pm him. i cant remember what i paid but i know it was cheap (perhaps it was cos i supplied him a drawing that he may or may not still use)
Current 4wd: Surf Kzn185 ssrg factory Intercooled (yet to start build)
Past 4wd: toyota surf ln130, coil sas, 1uz v8 build
Past 4wd: toyota surf ln130, coil sas, 1uz v8 build
Re: WTB: KZN130 3 or 4" panhard rod drop bracket!
Yea I just looked through mymold pms and I had messaged him.was quoted $230. Will stick to looking for a second hand one or might try out this offshore crowd. Spending too much $$ on this damn truck so need to start saving some coin on what I'm buying for it
Re: WTB: KZN130 3 or 4" panhard rod drop bracket!
Where in aucks are ya?
Can prolly make one up, but I'll need the vehicle, or some very accurate measurements....
Can prolly make one up, but I'll need the vehicle, or some very accurate measurements....
Re: WTB: KZN130 3 or 4" panhard rod drop bracket!
au surf site has a diagram with measurements.
if i remember right 3" is the smallest you can go.
if i remember right 3" is the smallest you can go.
Re: WTB: KZN130 3 or 4" panhard rod drop bracket!
DEATH_INC wrote:Where in aucks are ya?
Can prolly make one up, but I'll need the vehicle, or some very accurate measurements....
Will PM you now, I have diagrams with all measurements or can probably bring truck to you.
Re: WTB: KZN130 3 or 4" panhard rod drop bracket!
tweake wrote:if i remember right 3" is the smallest you can go.
That makes sense, when I made My terrano one it was the same...you need it to allow the panhard to fit into the wider part of the bracket.
Re: WTB: KZN130 3 or 4" panhard rod drop bracket!
Yea that's fine, did a rough measurement on mine yesterday and my RHS mounting point needs to come down about 100-120mm. So might even get a 4" one.
Re: WTB: KZN130 3 or 4" panhard rod drop bracket!
Found them from the states pre-made 4" suitable for 2-3" lift $100 incl shipping. If anyone needs one let me know.
Re: WTB: KZN130 3 or 4" panhard rod drop bracket!
bronx89 wrote:Found them from the states pre-made 4" suitable for 2-3" lift $100 incl shipping. If anyone needs one let me know.
pm sent
- bob_or_jim
- Hard Yaka
- Posts: 277
- Joined: Mon Jan 23, 2012 10:47 am
- Location: Sunny Southland
Re: WTB: KZN130 3 or 4" panhard rod drop bracket!
http://toyotasurf.asn.au/techsite/downloads/PanhardRodDropBracket.pdf
This is off the Surf ASN website.
Enjoy
This is off the Surf ASN website.
Enjoy
Re: WTB: KZN130 3 or 4" panhard rod drop bracket!
Yup already had that cheers anyway.
Who is online
Users browsing this forum: No registered users and 12 guests