Spent a couple of hours making one up yesterday, 3 hole type with the offset handle like the one below, but my ones a bit rougher coz I used the welder to fabricate it, anyway if you are in Chch you are welcome to borrow it (or further afield by arrangement), as the viscous fan can be a bit piggy to get off if you can't get a good hold of it and stop it spinning when you put the 32mm open ender on the nut. (LH thread as well)
Range rover L322 V8 viscous fan spanner
Who is online
Users browsing this forum: No registered users and 20 guests