TD27T into Land rover series, has anyone done it?

Bugly
Stropper
Posts: 5
Joined: Sun Jul 31, 2016 10:59 pm

TD27T into Land rover series, has anyone done it?

Postby Bugly » Sun Mar 03, 2019 8:39 pm

Hi all,

I am looking to install a TD27T into a land rover series 2A, has anyone here done such a conversion and if so any tips?
I am gonna swap out an LD28 for the TD27T, don't want to turbo the LD28.

Cheers Bugly...

nickmcdonald
Driver/Navigator
Posts: 34
Joined: Thu Nov 01, 2012 8:04 pm

Re: TD27T into Land rover series, has anyone done it?

Postby nickmcdonald » Mon Apr 08, 2019 11:28 am

LD28's are 6 cylinder correct? I'd imagine going to a 4 cylinder it'd free up a bit of room long ways.....not sure how the width or depth compares though. I'd imagine you'd have to fab up all of the mounting hardware, as nothing would exist off the shelf. I reckon just hang the new motor in the hole, see where things touch and start formulating a plan from there, as you'll be one of the very few to attempt / do this swap! :wink:

User avatar
naffa88
Newbie
Newbie
Posts: 2
Joined: Thu Mar 04, 2004 12:00 pm

Re: TD27T into Land rover series, has anyone done it?

Postby naffa88 » Sun Apr 14, 2019 8:58 pm

I haven't finished a conversion but have started one in a SIIa.{its a very long term project} The TD27t is sitting in the chassis with the bulkhead, front panel with radiator and guards in position. I am trying to keep the chassis original so have fabricated some engine mounts to bolt to the engine which will use the original chassis mounts. I have also got a Nissan atlas gearbox in there and have made an adaptor to the Landy transfer case. The transfer case is in the original position to keep driveshafts original. The engine is sitting forward so that the fan and fan hub assembly will have to be removed and an electric fan fitted. The turbo also interfered with the bulkhead so I removed the exhaust manifold, made some adaptors and refitted the manifold upside down. This moved the turbo from the No.3 cyclinder to No. 2 cyclinder area. The turbo dump pipe is still close to the bulkhead. This also means that the alternator has to move forward. I'm planning to use an alternator without a vacume pump, a single belt pulley and align it with the front pulley on the crank. The sump on the TD27t that I have also interfers with the front drive shaft so will have to be changed. I think the Nissan Atlas sump might work. Currently trying to get the gear lever assembly to work under the original gearbox tunnel. (its pretty tight). I've heard of other Landys with TD27 fitted but not with turbo.
What gearbox and axle assembly are you planning to use?

quattro
Driver/Navigator
Posts: 47
Joined: Fri May 01, 2015 12:23 pm
Location: Hastings

Re: TD27T into Land rover series, has anyone done it?

Postby quattro » Sun Apr 14, 2019 9:38 pm

Would be easier to fit a 200tdi engine
Discovery 4bd1t project

Return to “Diesel Engines and Modifications”

Who is online

Users browsing this forum: No registered users and 2 guests