Hi im after a starter motor for a 1990 Ln130 surf 2LT. In good working order cheers.
email warpphead@yahoo.co.nz
cheers

Where to start. I have a 90 surf that has oil leaking from the back right wheel. does anyone have any tips on
replacing the bearing and the seals and do i need to replace anything else in there cheers

i traced it back to the relay it was bugged

i have a 1990 surf. i have just replaced the contacts and the plunger , spring . It will start on the odd occasion but most of the time it will just click. i have got a brand new battery as well. any advice would be great.

all working now replaced the contacts and the plunger

i still waiting for sum points to arrive as im in tarras of all places.

Hi i have a LN130 surf that wont start, i have had the stater to bits an cleaned an it still wont start. the starter motor just engages but wont turn the motor over it just clicks . has anyone got any ideas cheers :scratch:

i have just done a 2" suspension on my ln130 surf an i cant get the panhard rod back on the rear diff. does anyone have any ideas why it wont go on or do i have to buy an adjustable rod. :scratch:

i shoot a poussum with a .243 magnuim from 5m an it skined it an cooked it in one go

cheers i will go see him tommrow

hi im in chch an have almost finish lifting my surf an doing a few other things all i need now is to get it all certified. Could any advise of a place to go in chch an approx how much will it cost :sniper:

can i run the exhaust over the top instaed of under or will this cause problems :scratch:

i am half way through lifting my my surf an hit a dead end with the exhaust pipe is there another way i can run it with out it gong under the front drive shaft where it will get squashed any ideas would be good.

are you trying to wire up an after market gauge to the factory sender.
if this is the case your gauge wont work.

i have got working motor out of a LN130 surf if your intrested

cheers will look into it. Another problem i have got is when i drive along the turbo boosts but when i change gear the boost gauge drops back to 20hg then it take a few seconds for the motor to respond be for it revs again is this related to a turbo problem or is it somethig to do with the fuel pump ...

just 50mm. just about to start suspension lift.

has anyone got any info on a turbo out of a LN130 surf. It has started blowing oil out of the intake of the turbo an out the other side towards the inlet manifold. i have disconncected the engine breather that goes into the intake. there is also a bit of movement in the turbo shaft aswell. is my ...

just finished doing body lift all went well.

lol good point cheers

when doing a body lift on a surf can the packers be longer than 50mm
an is there any down side to going over 50mm

could anyone tell me is it ok to take the engine breather hose off that goes back into the air intake cheers

hi i was just if anyone could tell me what parts i would need
to do a suspension lift on my surf. what is the max i height i can get out
of the suspension both front an back
cheers