Check all the bushes in the rear end

Still looking?

Diesel Maintenance on port rd are good

Non turbo will have mechanical fuel pump no ecu. In an ideal world fit an egt gauge and adjust fuel using that otherwise just half-1 turn on the fuel screw if running standard boost

Up for sale already?

Chuck a turbo on it, easy as and you'll be pulling 100ks up hills easy

Speak of the devil http://www.trademe.co.nz/motors/used-ca ... 993708.htm

Main problem would be getting the springs that model of jeep is very uncommon here

SJ413's also have a slightly taller 5th gear to account for the lower diffs I believe

Santas60 wrote:Hey man, thanks for the offer, appreciate it.

however i want to get the zuk road legal..... not sure if flipped rims are legal?

Technically probably not but most wof inspectors wouldn't notice

I'd say $1500-$2000. I was looking for a while and wreckers were asking $3000+ for non turbo motor, I ended up picking up a good low ks non turbo motor locally for $800 but took a while to find

Use regular 70 series springs for the front ie 70 71 73 74 and I have seen on another forum that the new V8 cruiser wagons have rear leafs in similar dimensions as the older 77 series. The model code for the new cruiser wagons is VDJ76

Factory tyre size is 205/70R15, about 26". I would suggest 7' wide rims as they hold the bead better at low pressures especially if running the narrower 30x9.5s

Crawlerer79 wrote:

zukmeista wrote:Pretty sure that's my swampers ya looking at

Then I think I just bought your 15" high offset steelies haha small world

It sure is! Hopefully they aren't delayed too much

Pretty sure that's my swampers ya looking at Biggest challenge is finding 16" rims with suitable offset in Suzuki stud pattern

Do tell

Cheers for the advice

tweake wrote: different flywheel is what i was thinking of, so possibly different clutch setup.
afaik the qd32t has stronger rods and pistons. a lot more suitable for getting a lot of power out of.

Are you sure? Cos if I'm gunna do a rebuild I might as well do it with the best bits.

slidenyo wrote:also of note harry qd32 non turbo to td27 turbo require a different throwout bearing due to flywheel offset and fork to pressure plate fouling in some cases

Cheers, rather stick with QD32 anyway

to keep it in context anything except a 2.4 hilux would leave a 2.8 hilux for dead :D :D True... Have had a 2.4na hilux on 35" silverstones and it still went pretty bloody good, 100kmh wasn't too much of a struggle! Have also driven a 3.0na hilux which was just about slower than a 2.8... :roll: The ...

To be honest it was pretty bloody good when it was going, would leave a 2.8 hilux for dead! Still got turbo kit waiting in the shed for the new motor though haha

Apparently the guy had a good motor in a wrecked D22 that he sold and got this motor as part exchange so condition mostly unknown just going off what he was told hopefully the gamble pays off. From what I understand the non turbo QD32 in navaras have a 6 bolt crank and the QD32ETIs have a 7 bolt ...

Have found a long block in Christchurch which was apparently a bit tired and smokey, guy wants $500 for it was thinking maybe worth a go to rebuild it and have a mint motor?

I did ask but they weren't keen to split... have been asking around today and getting the same story

First place quoted $3500, second was $6250 + GST ex south island

Didn't even think of google just searched trademe Thanks for that I'll ring them tomorrow

Cheers if ya could that would be awesome

Just got to know where to look....Nissan elgrande people mover generally non turbo and a lot cheaper. I know the caravans came out with the QD32 couldn't find anything there... Just searched the elgrande on trademe and couldn't find much. It appears all factory turbo versions have the electronic ...

Got a D22 with the QD32 in it, has had a switch in it for a looooooong time according to previous owner and been abused savagely... So probably done at least 500,000ks? Anyway something inside the block has decided to try and exit the block creating a nice inspection hole :( Have yet to investigate ...