I recently had my temperature sensor replaced by an auto electrician and in his attempts to get an accurate reading from it he wound the gauge forward with the result that my truck often records temperatures in the H zone when in fact its not. I've had the dash board out but haven't figured out how ...

Guys I am in need of a replacement fuel pump for my Fez. Mine leaks oil and i'm told at some stage in the near future it will die completely and probably when I'm a long way from anywhere - does anyone have one in their spare parts that they would be prepare to part with for a reasonable price?? I'd ...

Folks Last year on one of the various Feroza sites I found two sets of plans for the construction of mounts for the rear section of my Feroza. This year, despite multiple searches I cannot locate either and now I really need a plan - mutter mutter mumble. Does anyone have copies of the plans, a ...

For sure - I have been reading the manual and it certainly looks doable so this Saturday weather permitting I'll rip into it (with great caution)

No probs - Bad luck tho so I hope the rebuild goes well.

I'll look at doing a gasket change as the pump works fine so that suggests the oil leak might (must) be the gasket although I suppose it could be something else.

Yes indeed - I'm looking for a fuel pump - mine is oozing oil all over the place.

Cheers

Chris

G'day Dual batteries - I have just got started. Brought a battery tray and have mounted this on the left hand side of the engine. Got a battery ready to go but need to buy the isolator thingy - about $90 at super cheap so saving furiously. I have just fitted (manifold slit in four places) a free ...

Aw don't tell me things like that - how can I check them? What sort of $$ are involved? etc etc

Sorry yes they are manuals the car is a '91 1600 carburater - nothing fancy.

Seems real strange to me

Guys I got slightly off the road today in the snow and had my lr wheel in a ditch no sweat flip it into 4wd and away - nope. The light came on all good but I went nowhere and the dude standing on the road said "put it into 4wd' mutter mutter mumble it is said I - nope said he front wheels are not ...

Dropped into my local garage at lunchtime and spoke with the owner. He started the engine lifted the lid and said listen can you hear that? Hear what? I said all sounds good to me - you have a small leak at the manifold probably only the gasket but these things are known for cracking the manifold ...

I've done about 20,000k's since December. It was a new filter installed it myself. I don't think it's got wet and the truck is used daily so plenty of drying I would have thought. If I find it again I'll blow it clear into a plastic bag then we can have a look at it. In all my years of driving I ...

Nope not mould - remember the air compressor blew it away in clouds

Sounds like good advice

No the air cleaner is only about 4 - 5 months old. Air is drawn from the front left by the head light and a hand placed there reveals a good flow of air - the truck does have a vacuum operated flap that would draw air off the manifold but I haven't really checked this there being an apparent strong ...

I was on the hunt for why my spark plugs were all sooted up, why my fuel usage had gone up, why power was down and why under hard acceleration my truck miss fired. I replaced my Spark plugs and got some improvement but not much (guess I now have a spare set now :=) ) but what a shock I got when I ...

Hmmmm the sender has been replaced but alas the gauge remains lazy. A friend applied an ohms meter to it and said that the gauge was asking for a very large number of ohms thus the reason it wasn't responding. He turned the dial and at 32ohms the needle on the gauge rose sweetly to a position some ...

I actually purchased a new thermostat but didn't install it after popping the existing one into hot water - it appeared to open and close ok - mind you I didn't have a thermostat I could use to test the water.

Sorry forgot the obvious - it's a 1991 Feroza, 1.6 litre carburator model - is that whats called a HD 300??

Gents My temp guage is lazy, rises only a little unlee really hot then it would get to about one quater of the scale at best. It's been suggested to me that I remove the sensor from the block and give this a thorough clean. Thoughts, comments, suggestions and where abouts is this sensor hidden ...

Has anyone got an analog clock in good working order for a Feraoza - I would like to replace my current digital one.

Meece Cheers & thanks for that - Any chance of a picture of what I am looking for with the idler arm? On the rattle - interesting you should mention the anti rattle on the brakes - I had the front brakes donea s part of a warrant service and I don't recall the rattle prior to that mind you I wouldnt ...

Meece Got the Inclinometer going well - many thanks. Can I expand my questions?? I have just done a round trip of 1200k's into Milford Sound and back via Te Anau Manapouri etc =- great weather, great trip nearly got cleaned up by a well to do dude driving towards me on my side of the road not to ...

Meece Indeed I did resort to the hot glue gun - went for a drive this am and it worked great on the way out - it locked up on the way back but freed up when I pulled it out of the dash and gave it a wee tap. If it does so again *& I guess it will) I'll look at adjusting the needle a bit. Hey many ...

Meece

All has gone really well except the super glue won't set/dry! I wonderedif I had got a little of the oil on it but I can't really see how - hmm next step??

Meece

I got one - it was working at time of postage but has arrived in the broken stage. You mentioned they were easy to fix - can you tell me how or point me to the instructions on how to fix it

Mine has the clock and the battery gugae but alas no inclinometer. Yes indeed I am actively perusing trademe and chasing the ones that come up I just missed one the other day by moments.

Still - thanks anyway.

Just purchased a wee feraoza that lacks an inclinometer - rewal keen to get one if any one has one for sale or giveaway

Cheers

Chris