has anyone had exprence with these new red laser bore sighting tools are they any good or not

sorry don!t have any photo have sold challenger.Too much movement sideways breaks the bottom ring of the shock.Fit a rear locker don!t need to remove sway bay, will transform your vehicles off road ability. Best tire size 31 however will take 32 with 50m suspension lift You would be well advised to ...

Hi. Yes go for new radiator buy from mitsubishi will cost you a bit more .My first radiator was an import out off (china) cost me the second head Fit water temp gauge top radiator hose I fitted my egt gauge just after turbo can fit before turbo just keep temp under 600c and i had no more cracked ...

Having cracked two 4m40 heads this is what i did to solve the problem 1 Replace radiator. Only last appox 10 years 2 Fit E.G.T gauge do not go over 600c 3 Fit water temperature gauge,standard gauge does not tell you that the engine is overheating until it is to late.Temp should run between 75 an 85c ...

Own a 96 Mitzi Challenger. Have pulled front hubs apart countless times. That "ring thing" is part of the CV and should not be loose. However you will need to remove the hub to fix it. If it cannot be tightened by crimping suggest two very small welds. You don't want to upset the balance of the axle ...

sorry 2.8 D CHALLENGER 1996 A340H toyota box

Having trouble with my auto transmission. Cruising down the motorway at 80ks put foot hard to floorboard to pass. Truck has no power, just slowly picks up speed. However, when I flick the overdrive off it goes like a rocket. It would appear that it is not kicking down. Recently had secondhand TCS ...

How does one test a viscous fan.My fan has some resistance when cold but does not get any stiffer when hot. I thought the fan should stiffen up as it gets hotter, any ideas.

I'd like to thank everyboby for thier help.After extensive head scraching, testing, the technicians have found a fault in the throttle control sensor.Having this replaced will test and hopefully confirm problem solved. will keep you informed.

Hi can you help me haveing problems with my 2.8D auto transmission .Changes out of over drive into 3 for no reason ,this only happens after sitting over night.This problem will clear itself 1-2k further on after slowing down an flicking over drive button on / off .Serviced 30/5/2012 because of this ...

Hi i would check shock and sway bar both of these have caused poping noises on my challenger. Also tyrode joints
I would remove axle to work on the c.v

I have a rear set of ARB 50mm lift springs only 3year old if these are of use to you contact me Have had a new set made to give 75mm lift on rear also done top end filp front and wind up T bars 50mm

Hi Waypa here. The picture is of my truck. The adjustment of the sway bars is very easy to do. You only need to do a ball joint flip if you use up all the travel space. Yes Challengers do have a tendancy to tripod rear wheels, however I don't think this is any worse than most Surfs I have seen.On ...

I to have a 96 2.8 D and would also be looking at rear U/V joints, possible problems with slippery diff. Find some body who will let you exchange shafts,this will tell quicky and cheeply if problem is in SHAFT OR U/V JOINTS.

hi i own a challenger with tow hooks front and rear also member of manukau club. IF you wish to see my vehicle phone me evenings 2985087. Papakura. wayne