hello you can also wire then so they cant come if the head lights are running, this will pass a wof

Scott

you could run normal radiator hose inside exhaust steel to protected it , you can get it in 1 meter lengths for repco , but its not to cheap

scott

hi all

does anyone know where to get a adapter plate to do this ,im sure my one is not running true

scott
0211203155

hello you probably need a high tensile one, most places sell them

hello

maby try a motor rewinders, i could break it down and clean it up for you, but im miles away in Waitakere

scott

hello

i think you need one of the R series boxes, with a VZ bellhousing, unless you can get a VZ bellhousing thats made for the W series , you may need an adapter

hope that helps

they could be the same my ln130 and yn106 are different because of the axle, the 106 are just closer together, could be the same, i know this wont help much

hello

iv got one with no sensors off a 4y, if you send a detail pic of the plugs i might have the sensors and could mount them to the 4y one if you want?

scott
0211203155
scott.surfworks@hotmail.com

ok sweet

its the same as it was before i fixed the timing it is hard to start ,then it does but only for a few seconds, then it stalls, its hard to explain sorry for the little detail

scott

ok got a timing light and got that sorted, still not starting, any ideas?

i mean i think i have fixed it, checked the voltage and its 12.57v it will start but then it stalls right away

sort of, ok i will check the voltage it might be low

thanks heaps

both happened at the same time, its just the retaining bolt for little ajustment on dizzy, yea i tried puling the plug but still no good

thanks
scott

hello

no, im doing a 2jz ge swap with r1501f , i just made a little mod on factory x member

sweet about the loom

scott

hi all got my 2jz running in my hilux, was pritty mint, now can spin the wheels on the tarmac. Tthen i wired in the alternator and the problems started now its hard to start and when it does it just stalls after few seconds, its got spark and lpg flowing the dizzy came loose but iv tryed it in lots ...

iv got a yn106 one il try find it , it mite help

Hi jeremy

i have put a r150f in my ln106 im in the middle of wiring it up i can give you hand doing yours if you want?

scott
0211203155

i do behind my 2jz i have a solid axle one so not sure on the wiring for the vac but i do have the hilux book i can send you a copy of the page if you want, when you get the r150f/r151f you will need the loom and the 4wd ecu, (its under the radio), i just have an in and out switch and hold them down ...

sweet thanks for that will give him a call

hi all i have yn106 hilux iv done and engine convertion had the diff support hits the sump, i cant mod the sump because its were the alloy meets the steel , what will happen with out it (diff support) and can i extend it and move it to the other side? cheers scott 1991 Hilux d/cab Jzn106 2jz inline ...