$ for $ id go with the mudstar Radial m/t good on road off road and 245 75 16 about $230 or better each

Ive got maxi trax 50mm lifted leafes in my bounty ute good price and works well all i did was cut my overload leafs down buy about half to increase flex did it fitted cut buy cut so as to see results on ramp all good

How much better power and econ and were in the rev range or situation are you feeling the power increase ?

Depends on what tyres probably 7 or 8'' go to 4wd bits and look at their tyres as they state manufactures recomended rim sizes. BUT what offset ?

When I turn the key sometimes noting happens, sometimes it starts perfectly (after waiting for glow plug light to exstinguish). If nothing happens I seem to push the key harder or return it and it starts perfectly. This is a Mazda Bounty 2000. Is it a starter motor problem or somesome further up the ...

Thats all i need to know i apologizes profusely ..............

all the mods you have are of no gain off road or less this is a 4x4 site ? but looks very nice for street ?

Sorry i meant to say cutting the bar in half in middle and welding a sleve on it and then drilling sleve and bar out to take locking pin im sure ive seen this on another thread /site is this possible im kean to try what do you all think ?

Good topic i have the same set up on bounty ute and would like to disconnect front end why cant you cut and sleve the front aswell ?

yip i like them just put mine back on i use them as road tires now that ive got muds but they were a good all rounder and did well for a At in the mud ive done about 60000 km on them with about 3m tread in center and 5m on out side left. i drive pretty hard on the road as its my work ute and alway ...

I head out that way often dont forget the trevs that what i catch most but small bait we fish there then head over dunes and camp lots of dear never shot one but lots of tracks flounder can be speared on insided. Very dangrerous beach i only travel with 3 trucks and have saved alot of trucks things ...

Got my slow leek fixed turned out the monekes that mounted tires had gouged the tire and leftt it open to ingress at low psi the poor guys spent half an hour cleaning it up painting on sealant for a $25 fee see what hapens tomorrow at woodhill

castrol magnatec every 10 th anything other comes out like sludge expenive but in my opinion saves time and $$ on motor rebiuld

Im running 265 75 16 mud stars on bounty thinking about cutting every second lug off for more go in mud i only use these tyres off road what do you all think and what would you cut them with ?
All and any advice apreciated Ben

Somali Cruise Package I was checking cruise lines because I heard the rates are very cheap right now. I found a Somali cruise package that departs from Sawakin (in the Sudan) and docks at Bagamoya (in Tanzania). The cost is a bit high @ 800 per person double occupancy but I didn't find that ...

Pulled back rubber boot on slave cylinder fluid pissed out so new one from BNT $31 will fit when it stops pissing down.
Thanks for reply

My mazda bounty clutch was getting low in its engagment point and felt soft at top and hard to engage first gear so i adjusted it down by pedal . then it was engaging in middle of travel , but now feels very soft if not pumped . Its not going through any fluid as yet will check for leaks tomorrow in ...

Funny you should say that just had a overheating issue a few months ago are you saying high temps stuff glow plugs ?

I replace all 4 tested the old ones 1 was working just payed $150 for 4 at ripco only place open near me.
the brand was HKT Corporation made in japan are they any good same as last set i hope they last longer.

Can anybody tell me why my mazda bounty eats glow plugs with in 6 months from new ?
Thanks