As far as I can tell it has a speed sensor wire from the ECU. I won't be using this of course so trying to figure out the wiring just to get it to switch.

Hi There, Wondering if anyone can help me with wiring a factory Nissan GQ locker which is in a Hilux 4x4. Attached is a picture of what I have & wire colours, the solenoids (4 wires), the Off/On Switch (5 wires) and the Diff Indicator Switch for the dash lamp (2 wires). I cannot work out by the ...

Thank you very much to both for you!

Hello, I'm looking for some assistance on installing a Patrol factory vacuum locker. The diff is all setup ok, just wondering on the vacuum setup. I have all the bits i.e. canisters, solenoids hose, one-way valves, just not 100% on what direction the vacuum flows and via which cansiters etc. Does ...

Thanks. You're right in saying the 410 case be better. Mudslut, I will PM you about the spacer once I got everything sorted.

Do you know if the mounting points the same? Or what needs to be done here....?

Hello,

Wondering if anyone has or knows of any links to forums where they have put a SJ413 transfer case into a 1998 SJ80 Coily Suzuki?

Basically just after what was required to getting the 413 t/case in and mounted correctly.

Looking to get a lower ratio in 4x4 Lo.

Thanks in advance

Suzuki G16a 1600cc SOHC 8v TBI Fuel Injected (TBI) motor with single point injection throttle body, needs dizzy. Mech Fuel Pump "hole" needs block off plate made, have new gaskets for this. One bolt head break off on engine mount, shouldn't be too hard to remove as some thread left hanging out ...

Updated TM auction. Includes throttle body injection unit. Has new cam belt, rear main, new gaskets etc. Spares going with it. See TM for info.

http://www.trademe.co.nz/Trade-Me-Motor ... 077901.htm

Open to reasonable offers on 021 489 766

Updated TM auction. Includes throttle body injection unit. Has new cam belt, rear main, new gaskets etc. Spares going with it. See TM for info.

http://www.trademe.co.nz/Trade-Me-Motor ... 077901.htm

Open to reasonable offers on 021 489 766.

Hi There,

I have a G16a 1600 8v TBI motor for sale, link below to TradeMe auction. See info posted on TM.

http://www.trademe.co.nz/Trade-Me-Motor ... 351569.htm

Thought someone here might be looking.

Hi There,

I have a G16a 1600 8v TBI motor for sale, link below to TradeMe auction. See info posted on TM.

http://www.trademe.co.nz/Trade-Me-Motor ... 351569.htm

Thought someone here might be looking.