Hi all,

I am removing a bodylift from my KZN130, however I don't have the factory bolts that hold the body to the chassis. Does anyone have the measurements of them? Cheers

got it sorted.. thanks guys

Riccarton, its a 1995 KZN130 surf. The mounts just need to moved 2" higher and the indicators hooked up.

Hey all,

Just wondering if anyone could recommend a place to modifiy my ironman winch bar to suit a 2" body lift and fit it? Somewhere in Christchurch ideally.

Thanks

Hey, does anyone know whether a rear bull bar / tow bar from a LN106 will fit on a KZN130 surf? If modification is needed, do the brackets need to be changed?

The bar in question is http://www.trademe.co.nz/motors/car-par ... 641652.htm

Cheers

Hey all, I have a squeak/rattle that is coming from the back of my manual KZN130 surf. The truck has a 2" suspension lift, with raised coils and torsions wound up. This doesn't occur all the time, mainly when slowing down and when I'm off the accelerator. I don't think its my drive shaft as it was ...

know the person selling this one, is a very tidy and well looked after example http://www.trademe.co.nz/motors/used-ca ... 647737.htm

where are you located?

After a ARB style bull bar to suit a KZN130 surf, and also the parts required for a coil sas swap. Preferably in canterbury.

Thanks

I'm in Ashburton, cheers

Hi,

I am after an adjustable pan hard rod for a KZN130, or diagrams so I can get one cut out. I am also after a 32" bighorn tyre suitable for a spare - low tread is fine.

Cheers

Im not too fussed, although would prefer manual and diesel. Anything considered if it is a runner.

Hey guys, after a cheap river hack in the Canterbury area. Doesn't matter about WOF or rego, looking to pay about 1k. Thanks

Hey, do you still have this rear bar? Cheers

hey, do you still have this?

Thanks but sort of after a river / bush hack

Preferably in Canterbury area. Don't mind about reg or warrant. Can be rough.

I have four prado rims in good condition with center caps, 16x7, unsure of offset. 2 of the rims have 265/70/16 Maxxis Bravo 751's fitted, 1 has a 265/70/16 Terra-Trac fitted and the other has a BFG AT 31/10.5/15. All tyres are warrantable. Pick up is from CHCH, after around $300. Cheers m - Rims ...

Sweet thanks guys. Also where could I find center caps for 15x8s , similar to http://www.roughtrax4x4.com/media.php?file=2394 except black?

Cheers

Hey guys,

Just wondering what places you would recommend for tyres in Christchurch. I'm after 4x 32" mud tyres for a 15" rim, preferably Maxxis Bighorns.

Thanks

No I havent had a wheel alignment. Ill have to get one done, thanks

No I left the wheels on. The only thing that was removed was the shocks and sway bar and I double-checked them

Hello, Recently I installed a 2" suspension lift in my manual KZN130 surf , and after the lift have noticed that the steering wheel will vibrate from 20 - 30km. It could be a wheel balancing issue but I think its wierd that it is only noticeable after the lift. Do you guys have any other suggestions ...