Hi, I have a 4 speed gearbox with transfer which is surplus to requirements.
The gearbox has a dodgy 1st to 2nd syncro but the transfer is good. No parking brake drum.

I'm in Auckland.

top

http://www.trademe.co.nz/Browse/Listing ... =731437450

Closes soon.

bump

Here:
http://www.trademe.co.nz/Browse/Listing ... =728612174

Bump..
Still looking.

Hi, 60 Series power steering box with pitman arm?
Cheers

Hi Guys,

After a flywheel for a 1HZ or 1HD-T.
Wreckers are after an arm and a leg.

nickjreid@gmail.com.

Cheers

I think you might be struggling with what you want 38mm were later model with axle handbrake set ups And vacuum front output engagement Reasonably certain that a rear output off a earlier 34mm box will fit onto the 38mm box just beed to check the shims etc. You will need to mod the later box to get ...

Hi Guys, After a Split Case to go behind an H55F going into my 40. Would prefer later 38mm idler, and transfer mounted parking brake (this is pretty rare, so may be dreaming). Manual shift preferred, not vacuum. Don't mind if it needs bearings/seals etc but gears must be good. Anyone got one? Cheers ...

mudlva wrote:Got one here pm me an offer
Got one on the floor and also still in a vehicle
Booth will be fine spline

Cheers, really keen to find a 10 spline, but will definately keep yours in mind.
Both in good nick?

Cheers

Big wrote:I know of one that a real good runner.. how much you want to spend will depend on weather he'll sell it.. but it's just sitting atm..

Cheers mate, is it 10 spline on the input? Interested.

Hi All, I'm after a Toyota H55f 5 speed, as fitted to late 40 series, 60's and some 70 series. Transfer case too, though must be Manual Shift (ie. not vaccumm). Prefer 10 spline input (ie from behind a 2F or 3F) but 21 spline could work too. Prefer good condition, ie easy to shift, no crunchyness ...

Hi all,
I'm doing a 1hz H55f conversion on my FJ40, and i need a gearbox crossmember for the H55f, and the L brackets either side.

Could be a bit of a long shot as i know there's probably not many around.

Like the bottom one in the pic.

Sorted now.
Cheers

Hi there,

After a set (4) of 40 series steel rims, like those in the photo.
Don't care if they have or dont have tyres or are a bit rough - plann on powdercoating them.

Cheers

can anyone tell me conclusivley if the SNR bracket, 70 series rotor and mr2 caliper combo will fit my semi-floater rear?

Or if snr bracket will fit my semi floater and i can use another combo?

Cheers

Did a quick search and the mr2 caliper conversion seems choice, do these brackets fit semi-float axles?
http://www.snr4x4.co.nz/caliper-bracket ... p-238.html

Anyone know of a bracket availible here or a template?

cheers, whats the general process for certs? Can i do all the work then get it certed or does the cert geezer need to have a squiz before i do any work?

Hi Guys, Recently purchased a '78 FJ40, with Drums all round. My intention is that the truck will be a semi-daliy driver/trip rig. Nothing to major offroad etc. Ive got the front disc brake setup from a later 40 (1981) (everything from shafts out) and my intention i to swap this gear over in the ...