mine is out of round beyond grinding and also looks to be cracked. 750 is very cheap i was quoted well over a grand at trade. i also have a trade account at repco and it was still just over 900.

Looking to buy a 3l crankshaft in good condition. Alternatively has anyone had experience using one of the Chinese crankshafts available on trademe?

Looking for a replacement manual locking hub for my 86 surf, only need one but will buy a pair if i need too. Second hand or new ones at a good price!

I have a mint set of 6 stud white 15x8 steels. $300. Cheers.

Four tires no rims. Two are in excellent condition with even wear and a minimum of 10mm in the center's. One is evenly worn but run down to a minimum of 6mm in the center the last tyre is a bit chopped out on the outside but has about 5mm in the center and more tread on the inner edge. Open to cash ...

Need a front left guard and a left side light for ln61 surf. Not worried about color or scratches in paintwork but would prefer reasonably straight! Cheers.

Choice. Any plans fir another this year? Also, sounds like i shal be ok if i dont mind scratches? You'll be ok providing you have a good level of experience and you take it easy. I lived and worked in the area for 5 years and have done the 42 more times than i can remember but the moment you let up ...

Can anyone recommend a reliable diesel shop to flow test a set of injectors i picked up as spares? Wellington area.

Hi, After someone in the Wellington area that has access to a folder capable of folding 6mm plate for winch mount. Only need 1 fold done over a length of 550mm. Plate will be marked out etc. Any help greatly appreciated.

Run an in cab momentary push button with a 30 or 40 amp relay fed direct from starting battery to the glow rail. Push button triggers relay, relay supply's current to glow rail. used same setup on a 3L that i put in a series 3 landrover.

Cool, will have to suss out a time before work to head out and see you. I don't suppose you have any silo section do you? Cheers.

Looking for box section, flat bar and c channel for making up rear bar or an engineering shop that's happy to sell small quantities? wellington area?
Any help appreciated.

Thanks for your reply,

It would appear i am now going to need a new head!

Can anyone tell me if an early roller rocker type head will bolt up and work with a later model 2lt/2lte block? As far as i can find via the internet the bottom ends are essentially the same but i'd really like to be sure before i start putting a new motor together. Has anyone done this? Or is there ...

Could be keen on the a/c pump for air compressor conversion.

Tight budget means that i've got about $400 to put a motor together with at the moment!

Cheers.

Putting together new Toyota 2lt bottom end have a bare block, rods, crank and new pistons. Need everything else....On tight budget. Wellington area.

Also after Ln61 Interior parts, drivers kick panel, drivers armrest and plastics that cover rear canopy bolts.