Hey all My front facing, front drive shaft transfer case seal has gone around Christmas time and is whizzing on my drive way All the stores are shut, does anyone know the exact seal size/dimensions so that I can just grab one off the shelf ?, I do not want to pull my seal out yet.. and I suspect it ...

Weemsy wrote:If there is a bleed nipple on there, bleed it before the wheel cylinders

I found it last night be left it alone on account of having good pedal feel And you where right on the amount of bedding required

Pass the WOF no worrys today Thanks man!

I think my problem is not the same but one of you may have an idea. I have a Suzuki Escudo 91 and the drum was very hard to remove from the axle. (The handbrake wasn't on) when I put the drum back on again it was very hard and needed some hammering. Is this normal? If in turns %80 then locks up, I ...

Get a hacksaw blade and drag it across the lining in a criss cross pattern to get a good scoring on the lining. Bedding in rear brakes are always a pain on light vehicles. Can you wind your load sensing up to get full pressure to the rears? Thats a really good idea!!! I could trick it indeed ...

I used some Castrol VMX in mine She was shifting a bit b$tchy and that helped alot! There is a plug on the RH side of the main box for the filler hole. The filler hole is the level, so fill it up until it over flows a little and wack the plug in. So just drain it with the plug on the bottom, seal ...

Its certainly not my first shoe replacement on vehicles So this one has taken me by surprise at its failure... Mind you.. I have never replaced slave cylinders out of reaction to a wof fail ... have only changed them out of run away down hill fails... So I am %100 certain I have done it correct, but ...

Check the drum diameters as I suspect that if they are different or out of specification this will have an impact on the brake preformance. The drum diameter I am assuming is in spec because I had it machined by Waikato clutch and brake. The feel is firm, but not stiff and not spongy I bleed the ...

Hello I have recently rebuilt my rear brakes, slave cylinders, machined drums, brand new shoes I am getting some really bad rolling brake test results failing a wof, 70L/30R (VTNZ) From inspection I can tell that my right leading shoe has less friction material/contact on the drum then the left ...

your ac should have a round tube thingy like this with a pressure sensor on the top. pull plug and link wires with wire, turn on ac button and if works low gas pressure Fantastic!!! I did not know they had low pressure sensors ! This is what it will be for sure! as the light does turn on for the AC ...

Hello Has anyone had any experience in diagnosing a fault with an Escudo where the air conditioning solenoid does not click in to engage the clutch, nor does the condenser fan start, or the engine change in rpm. I have checked all fuse's with no joy I suspect there is a controller for the aircon in ...