Can u email me some photos of your truck finished cheers David

gsr_sigma@hotmail.com

Yea I love the power my truck makes it flys in the mud I'm going to turbo mine in the near future

Wish I had a cert guy like yours the cert guy I rang told me I need to drive shaft hoops on mine mines two piece shaft aww mines not the best on gas $100 gas gets me 380 to 400kz only just on my 33 MUDs. it's way better on gas when I have my little a/t 30s on but looks out of place with the truck as ...

Hay mate how did you go about the drive shaft hoops is your drive shaft 2pc I love my 3rz conversion

U have to drain the water from the motor Unbolted the throttle body from the intake (two 12mm nuts and two 12mm bolts) there are two water lines that run under the throttle body to the idle valve then there are 4 little screws that u need to take off to clean the idle valve(be mindful of the rubber ...

Truck is pretty much finished it's driving and goes like a dream compared to my old 2.4d motor had one problem when was going the idle was high as he'll but the I.A.C was stuck open pulled it out cleaned it up with bit of brake clean now idles how it should would upload photos of everything I've ...

Can any one shared some help on the wiring part of my conversion it's pretty much the last thing I have to do for the truck to be going 02102717632 or email me gsr_sigma@hotmail.com

Any one help me I'm trying upload photos of the progress of my truck but it won't let me don't know why

As for my progress I bolted the 3rzfe bell housing to my standard box and test fitted motor bolted it the box . I'm using my 2l rubber engine mounts bolted to chassis used 10mm plate from my 3rzfe to mate up to my rubbers and welded them will upload photos as soon as I can

Like I was going to run a inline pump with my diesel tank and have it wired up so that it always ran when the key was in the on position or should I run it through the efi relay way to be on the safe side

Thanks I went and found me a plug off a 2.4dt surf one question do I need to bother with the efi set up if I'm going to run a in line fuel pump hard wired up.?

Thank u for ur input can any please help me I got my motor but it looks like I'm missing the 22pin plug on the ecu ? Isn't that the main plug I need

Cheers wil do that in time to come motor turned up today will b sorting it out

Wil upload photos of the build as I'm doing bit by bit

Doing a ln65 build with a 3rz swap
Mods so far are
2" suspension
2"body lift
And 33x12.5x15

Want to move front dif forward but not wanting to do a RUF
any suggestions

Mint project mate I'm doing the same conversion to my ln65 lux any info will be much appreciated