trademe listing:
Navara D22 Rear Axle, complete
Closes: Fri 3 Dec 8:00 pm (#3364718695)

It's going to the tip now....

Hi, i have a D22 rear axle with a shot diff. The splines on the axles are fine but the actual gears are destroyed. It used to belong to my 2005 Navara which I no longer have (axle was supposed to go with it but space constraints on the transport prevented this). comes with the bake line and drum ...

trademe listing https://www.trademe.co.nz/a/motors/cars ... 2882549383

also: can anybody tell me which years are compatible? Ie can I use a 09 LSD or is it best to just order the defect parts from Nissan and replace those instaed of the whole Diff?
Cheers.

Hi guys,

my rear LSD(ifferential) and the gearbox seem to be packing it in - at the same time, lucky me

who has got a manual gearbox and rear differential (LSD) for my 2005 D22 with a ZD30 engine pls?

Ta. MM

Hi guys,

my rear LSD(ifferential) and the gearbox seem to be packing it in - at the same time, lucky me

who has got a gearbox and rear differential for my 2005 D22 with a ZD30 engine pls?

... in the style of an Ironman Commercial, MCC Rocker, ...outback accessory,...
The Navara is 2005,not sure if that makes a difference vs the newer, is it 2.5l?, models.
Offers please, ta.

can call me,too, of course 021 2179883

... for my 2005 3l.

Anything considered like ARB, ironman, genuine Nissan, ...

sold

sorry still didnt get to take photos.

Hi, I've finally decided to sell my 1984 Hilux Surf. I've owned this for 12years, but it's lately mostly been standing around in the yard as I have a Navara as my daily driver/work vehicle. It's a 3Y-N (2l Petrol) with 225tkm on the clock, has 16" rims with fairly good Dunlop Grandtrek AT2s on it ...

got it. too easy. might have a look first wether it's really dirty already etc.

cheers mate

Hi, looking for a used front bumper as per subject, the likes of an ARB, ironman, etc. (see picture) Contrary to the photo it needs to have cut-outs for foglights pls. It doesn't need to be exactly like on the photo... got welder - can customize 8) ... and while we're looking for parts: Does anyone ...

I can tell you one thing though, if you do rebuild it, use BD30 rods and pistons or aftermarket pistons and rods, the zd30 runs the largest gudgeon pin size vs smallest piston mass of any nissan engine with the qd32 following close behind. the effect the fastest heat saturation point...reach that ...

Hi Tweake,

ordered and installed!!! I did get the forefront ind. one which arrived pretty quick after we'd agreed on courier, OZ GST off, etc..

Installed easily, with a few tweaks on my truck. Thanks a lot for the info and safe trucking.

MM

Hi Tweake, thanks for your reply. Yeah really a bit incomplete without an IC (Nissan probably aimed for a certain pricebracket and omitted the IC in favour of a slightly lower endprice). According to my local Nissan tech (Grant Ward Nissan Alexandra) ,and that makes sense so far to me, adding an IC ...

I have seen these for sale on eg 4wd bits and just wanted to find out if someone has put one in and what the result is: more power?, less fuel consumption?, do you need to /can u chip tune it on top of that?, effects long term engine life?, .... ie is it worth putting in?

Hi, anyone here with experience on installing an aftermarket intercooler onto a 2005 D22 Navara (zd30 engine)?

news from the auto electrician: the rectifier is stuffed. cause unkown.

hi, has anyone swapped the brushes on an alternator of a 3y engine and could tell me how it's done in a few words?
(got the thing out and spun it up but no volts)

hi, has anyone swapped the brushes on an alternator of a 3y engine and could tell me how it's done in a few words?
(got the thing out and spun it up but no volts)

found this diagram: http://www.toyotasurf.asn.au/techsite/downloads/tailgate%20elecs.JPG

Does anyone know what that relay/switch does that sits inaccessibly behind the panel by the bottom end of the passenger seat belt (B-coloumn) or what activates it?

Hi, I have some trouble with my 84 surf (YN60): when I try to wind the tailgate window up or down with the key or with the centre console switch it stops somewhere half way or any where else. then wont go either way, neither up nor down. After a while it works again and I can wind it down. There is ...

Awesome mate, txt me and I'll call u to arrange how to get that tailgate up to Wanaka. 021 2179883
.... and the Speights down to Gore.

Hi, parts for my surf become hard to find: anybody out there who has a "window manipulator" for the tail gate window for my YN60? the little part that connects the window to the lever arm has literally rusted away. It's the one that the little pulley runs in, pushing the window up and pulling it ...

Ok done. I pulled it all out, gave it a clean and grease up and put it back in. Although, when I press some grease into the nipple it squirt out from underneath the rubber (yeah, go on, have a laugh!!!) forwards of the link/joint. I can't quite think that's normal. any thoughts?

cheers, will have a go at it in daylight tomorrow morning.

OK, now that I've identified the part, what could be wrong with it, how do I find that out and how do I repair it? tester said (on WOF sheet) that it needs adjusting.

Cheers for helping a layman!