Looking for a 4wd G52 gear box from a 3y 4y Hilux, any condition considered. Or just the bell housing…

Cheers

Got the sump back on, new gasket on pick up, poured oil in filter hole , sender hole and turbo feed hose with truck jacked up high at back to get oil to flow down to oil pump, fired it up and had oil pressure pretty much straight away... Hopefully don't have that trouble again after the trucks been ...

Is there away to tell with out removing the oil pump? I'll have a goood look at it tomorrow. Is it possible the pump lost its oil from sitting and needs to be primed to get it going again? Is there away to get oil in there? Filters are fram 2850 have been on truck for about 600ks and were on before ...

Cranked it for about 10secs then had it running for about 20secs then on and of for a bit trying different things.
Pulled the relief valves and cranked it for a bit and got nothing from them

Have just pulled the sump and pick up is still clean as. Removed pick up to inspect for cracks and there's possibly a very tiny one around the flange not so sure that's the culprit though.. will braze the join anyway Will get new sump gasket and refit still think the problems going to be there ...

Was pretty careful removing and installing the sump back and used very small amount of gasket goo on the new gasket.
But it's looking like I'll have to remove the sump again and check the pick up as you say it may have received some damage and that's looking like the only thing left to do..

Cheers

Have just Finished putting a turbo on my td42, took the feed from the plug by engine mount and removed sump to put in a oil return. Started it with turbo oil feed line off to make sure there was oil, but nothing... Oil light doesn't go out, have removed sender and cranked and nothing comes out ...

Cheers mate, will have a read

Going to lift my lwb Safari and will make some drop boxes.. But was thinking about changing the bush setup on the and of the radius arms to a rose joint and make the drop boxes to suit.
Would improve flex I would think..?
Anyone tried it? Able to get cert.. Etc..?

Cheers

Have a new 42" lightbar $230 and a 52" one $250

In chch but can post, cheers

After a kzn130 1KZ hilux surf for a project. Will consider anything, Complete,dead or no motor etc, live or dead plates. let me know what you have, will travel south island for right one.
Please Pm me, Cheers

After a Y60 safari body with live plates and rust free. Or a complete truck that's dead but with live plates.. prefer SWB but will consider LWB..
In ChCh, will travel for the right one. Let me know what you got..
Thanks

Still have the dump pipe to sell?