tyres for 413
tyres for 413
Hi guys, just recently bought a 413 and am looking at taking up 4wding as a hobby. So i singned up to the site just to take a look. anyway i need new tyres and was just woundring what the biggest size is that you can put on a standard 413 without putting to much strain on diff and gear box etc.
85 sj413 standard with 1600 motor and roll cage
Re: tyres for 413
31's will fit, need to bash a seam over here and there on the firewall, and get 15x8 rims with the most negative offset you can, I have Speedy Desert rats, which are negative 24mm and no rubbing anywhere, mind you I have fawk all flex
Cheers
Jafa

Cheers
Jafa
'85 Hilux crawler, 3rz, duals, 4.7's, 4.88's, ARB's, 30 spline Longfields, 6 stud SNR4x4 Histeer, Airshocks up front, coiled rear, 40" Iroks.
^^^this shite is all about to change....^^^
021 273 9942
jafa@inspire.net.nz
^^^this shite is all about to change....^^^
021 273 9942
jafa@inspire.net.nz
Re: tyres for 413
yep, as jafa said, 31s with lots of guard "massaging" and offset rims etc. The drive train can cope with upto 33" tyres, only thing is your gearing will be up the $hit
- moonhopper
- Hard Yaka
- Posts: 433
- Joined: Mon Jan 14, 2008 8:51 am
- Location: Napier
Re: tyres for 413
you can try 30" litlle bit narrower still gives good turning circle and not so much hassle with the gearing, but they dont look as good as 31's 

Last edited by moonhopper on Tue Mar 11, 2008 2:18 pm, edited 1 time in total.
Re: tyres for 413
I'm running 31x10.5 on 15x7 Mangles on my narrow track 413 , think they are about -24 offset
2" spring lift and 1" shackle lift.
The front tires rub on the rear of the spring pack at full lock , makes for tight turning off road
At full articulation the rears rub on the inside of the wheel well, the fronts rub on the shock mount and top of the wheel well.
My self and the previous owner have massaged the seams well out of the way in the front and i'm thinking of moving the front diff forward 25mm to stop the little bit of rub on the firewall at certain angles.
I also have 25mm bump stop extensions fitted front and rear.
Gearing wise with the stock 413 transfer and 3.9 diffs its a pig. Over runs going down hill in low first and have to keep your foot on the break. 2nd low runs out of power up hill and you have to rev the hell out of the engine to get speed out of 1st low.
Have been considering dropping back down to 30.9.5
but just cant bring myself to put on smaller tires.
I have a rock lobster conversion in progress(combination 84 410 and 85 413 gears) ,18% lower in High and 80% lower in Low. Should put the gear back to about normal with 31's in High range on road
But ultimately Trial Gear or Calmini transfer gear set ,then I can run 32's
Im still amazed though where a stock Zuk can go just on factory 29's
2" spring lift and 1" shackle lift.
The front tires rub on the rear of the spring pack at full lock , makes for tight turning off road

At full articulation the rears rub on the inside of the wheel well, the fronts rub on the shock mount and top of the wheel well.
My self and the previous owner have massaged the seams well out of the way in the front and i'm thinking of moving the front diff forward 25mm to stop the little bit of rub on the firewall at certain angles.
I also have 25mm bump stop extensions fitted front and rear.
Gearing wise with the stock 413 transfer and 3.9 diffs its a pig. Over runs going down hill in low first and have to keep your foot on the break. 2nd low runs out of power up hill and you have to rev the hell out of the engine to get speed out of 1st low.
Have been considering dropping back down to 30.9.5

I have a rock lobster conversion in progress(combination 84 410 and 85 413 gears) ,18% lower in High and 80% lower in Low. Should put the gear back to about normal with 31's in High range on road
But ultimately Trial Gear or Calmini transfer gear set ,then I can run 32's

Im still amazed though where a stock Zuk can go just on factory 29's
LR110 ..... LJ50 project
Chris.

Chris.
Re: tyres for 413
Yar I'm lucky, mine has 5.3 diffs, so gearing is sweet
Mine also has a 1" body lift which helps alot with clearance, Mine dont rub on springs, shocks or body at all now. 31x10.5's (Hankook RT01's) on 15x8's -24

'85 Hilux crawler, 3rz, duals, 4.7's, 4.88's, ARB's, 30 spline Longfields, 6 stud SNR4x4 Histeer, Airshocks up front, coiled rear, 40" Iroks.
^^^this shite is all about to change....^^^
021 273 9942
jafa@inspire.net.nz
^^^this shite is all about to change....^^^
021 273 9942
jafa@inspire.net.nz
Re: tyres for 413
I'm used to driving a Toyota
so gearing is the first thing im going to fix. Then Wide track diffs and 15x8 


LR110 ..... LJ50 project
Chris.

Chris.