hi guys and girls, i have a 2.0l v6 two door suzuki escudo 1995, which
on several occasions has taken small amounts of water into the coils,
making the engine to misfire. i have asked around and have been told
that sealing the covers over the coil packs will just trap
condensation, causing the same misfire. anyone have a solution? or a
trick they have done to there truck. any advice much appreciated.
cheers
water touchy 2.0 V6 zuk
water touchy 2.0 V6 zuk
If you never get stuck, your never trying hard enough
Re: water touchy 2.0 V6 zuk
hi,
i had exactly the same trouble with my v6 just before i sold it.
the only thing i found to cure it is to blow the coils over with compressed air to get as much of the moisture out as possible.
then keep clear with the water blaster and try not to go near deep river crossings
weemsy
i had exactly the same trouble with my v6 just before i sold it.
the only thing i found to cure it is to blow the coils over with compressed air to get as much of the moisture out as possible.
then keep clear with the water blaster and try not to go near deep river crossings

weemsy
Its better to keep your mouth shut and appear stupid than to open it and remove all doubt.
- cool__bananas
- Hard Yaka
- Posts: 791
- Joined: Sun Nov 05, 2006 12:00 pm
- Location: Lower hutt, Wellington
Re: water touchy 2.0 V6 zuk
what about cover them in silicone spray the cover them in glade wrap? 

Re: water touchy 2.0 V6 zuk
ill try silicone spray, dont no about gladwrap it might melt to the engine 

If you never get stuck, your never trying hard enough