rugger/blizzard axles

Rotazuk · Post by **Rotazuk** » Sun Apr 16, 2006 3:03 pm

Hi
Many years agao I looked at a set of daihatsu axles to put under my suzuki and found they were about 3.5:1 so canned it . Well now going to a lower ratio would work for a diesel zuk I have ( and besides I want the axles under it for something else ) .

So can anyone tell me what the spring width is centre to centre front and rear ?

Also if you know of a set lying abouy let me know as I may be after some . They will have to be cheep thou as you can get a hole car for $300-500 .

Cheers

Chris

wopass · Post by **wopass** » Sun Apr 16, 2006 4:41 pm

pete will probably be having a set for swap/sale soon as hes gonna put hilux diffs under his rugger...i think....check his thread on his project....i think :wink:

link to it

http://www.offroadexpress.co.nz/modules ... c&start=30

DieselBoy · Post by **DieselBoy** » Mon Apr 17, 2006 10:53 am

Yep my Rugger diffs are looking for a good home. I have no idea what state they are in, the odometer says 160,000, and it has been sitting for the last three years so i don't really want much for them.

I'm hoping that by getting rid of them i can somehow get a Lux front axle as part of the deal, weather swap or sell them for enough to go some where towards the price of one. I have a rear axle already.

The spring platforms are roughly 980mm apart, thats a quick measure with a tape measure from the out side edge of each (closest to the wheel).

Gimme a ring on 027 357 9547 if ya interested!!!!

DieselBoy · Post by **DieselBoy** » Tue Apr 18, 2006 10:50 am

Didn'y get a chance to post this up last nigh for ya, but:

Both Axles offset to the drivers side

Rear platforms 980mm
Front platforms 800mm
Front Axle width from hub to hub 1540mm (free wheel hubs are 60mm long so 1420mm)
From where weels bolt onto the hub 1380mm, rear is the same :wink:

Ratio's to come...........

Definatly interested in the set of Lux axles if there for sale, the welded rear won't be a problem.........

Rotazuk · Post by **Rotazuk** » Tue Apr 18, 2006 2:39 pm

Sent PM to you .

echothreezero · Post by **echothreezero** » Wed Nov 15, 2006 2:00 pm

Did you ever sell those axles?

I need the front one, but will take both if I have to...

Cheers.

DieselBoy · Post by **DieselBoy** » Wed Nov 15, 2006 2:10 pm

PM Rotazuk, don't know if he ended up using them, i saw the Zook he was going to put them under on Trademe a while back :wink:

Goose · Post by **Goose** » Wed Nov 15, 2006 2:31 pm

Hi, I know of another set, (front and rear)probably cheap, PM me if you want some details. :wink:

rugger/blizzard axles

rugger/blizzard axles

;-p