ideas for 80 series cruiser barwork

[swampa]

getting another 80 that will be the new play wagon, gonna bar it all up, anyone got any pics of good 80series barwork, already got a good winch bullbar, want rockslider pics, maybe exo???

[Jacko]

am after the same... need a winch bullbar too if anyone has one?

[coxsy]

seen this
http://www.4wdbits.co.nz/ProductDetails ... uctID=1067

[swampa]

i'm looking for rear bar work, rock sliders, snorkel ideas.. found a fair bit on 4wd monthly site

[swampa]

im looking to buy some cool rock sliders for an 80 series, dont have the time to make them, so anyone got some, remember im in invers

[NJV6]

You need to buy the Cruiser and get it out of my garage first!!

[swampa]

thats was sorted on friday, will get it tuesday, wednesday? might come around this morning and take the mrs for a drive, told bruce i would let him know for certain by the end of the weekend, what time you going?

[swampa]

this is the new family wagon,4.5 24v petrol, arb bar, 3'old man emu lift,33's, it needs: a winch, barring up, snorkel,storage in the rear, a strong cargo barrier, cb, gps...
wanted big tyres to stroke my ego but gonna stick with these and run chains as this is only a club truck
give myself 2 months to finish it off

[fweddy]

http://www.trademe.co.nz/Trade-Me-Motors/Car-parts-accessories/Toyota/Exterior/auction-215383272.htm

[red-devil]

http://www.sleeoffroad.com/
All Gear
http://george4wd.taskled.com/slider.html
Sliders
http://www.man-a-fre.com/default.htm
i get a few ideas off these boys

[swampa]

some good stuff, is there a kaymar supplier in nz??????, i like the look of the rear bar,
sent fully equipped an email about their rear bars, no reply yet.
by the way, i'm after a warn 8274-50, must be quite new and 12v

[red-devil]

dont think so there auzzy.

try pete monro

[furnace]

Scotty Newport [ engineering place ] in Nelson builds the best bars and rock sliders i have seen for half the price you will buy at a 4x4 shop..check my profile and our 4x4's

[Jacko]

just wondering if you have any contact details for these guys? also what kind of price are you talking?? cheers..

[swampa]

we started making rear bars out of 50mm tube,one on top of the other with a 10mm gap , looked pretty cool but didnt match the front arb bar, it doesnt match the look we want so we are going the full hog and making a complete rear bar out of 4mm customwood then getting it cut in 4mm steel and welded all up, will be tight, house a jerry can holder and spare wheel, will look like a kaymar rear bar just not as bulky
http://www.wildyoats.com/80_series_rear_bumper.htm