5mge farting and missing( HELP)

For all topics relating to Petrol engines and modificiations.
Post Reply
User avatar
monaro427
Hard Yaka
Posts: 492
Joined: Sat Jun 18, 2005 12:00 pm
Location: where i want

5mge farting and missing( HELP)

Post by monaro427 »

well as it says my 5mge is pissing around again, what i have done is new leads fuel filters, ok now what it is doing, started it up yesterday morning sweet as idled rev'd good as, drove it to the servo to put air in the tyres(it's about a 5 minute drive) temp just got up there so i turned the truck off to air up tyres but when i started it back up it was farting missing and not reving out the drive back was shit like it had droped a few cylinders, thats when i changed all the fuel filters, but no difference :( , so please help if you can, lossing total interest on the truck and 4wheeling slowly if i can't get it sorted, got to be something simple :(
User avatar
haynzy
Hard Yaka
Posts: 1144
Joined: Thu Jul 13, 2006 12:00 pm
Location: Palmy North

Re: 5mge farting and missing( HELP)

Post by haynzy »

fuel pump?
earth issue with coil?
cracked dizzy cap?
could be a number of things
start with fuel and air then check every thing
check to see that the airflow meter is not jamming
things like that :wink:
swb lux with 7mge, trailgear crossover, trailgear rear lift kit, custom front bar, runva 1200lb winch, custom snorkel, 37" Mtrs, custom deck, lockright in the rear.
User avatar
rokhound
Hard Yaka
Posts: 2558
Joined: Sat Apr 22, 2006 12:00 pm
Location: Christchurch

Re: 5mge farting and missing( HELP)

Post by rokhound »

there will be a small hole in the cross over pipe to the AFM Craig. (well maybe :wink: )
Bend the flexy rubber pipe and look for cracks in it.
Ugly is a state of mind..... and the state of my truck!
User avatar
Smurf
Hard Yaka
Posts: 2867
Joined: Tue Mar 04, 2003 12:00 pm
Location: Nelson

Re: 5mge farting and missing( HELP)

Post by Smurf »

A corroded dizzy and a dodgy AFM were the source of my motor running ruff. Was all intermittent too.
User avatar
rangimotors
Hard Yaka
Posts: 1631
Joined: Thu May 10, 2007 12:00 pm
Location: chch

Re: 5mge farting and missing( HELP)

Post by rangimotors »

rokhound wrote:there will be a small hole in the cross over pipe to the AFM Craig. (well maybe :wink: )
Bend the flexy rubber pipe and look for cracks in it.

I would second that one, that bastard pipe hates me! I think i have a spare computer and air flow meter in my spares kit. If you get stumped you could try them for trouble shooting but i would like to keep them.
Never argue with an idiot, they drag you down to their level then beat you with experiance!
User avatar
Steve_t647
Hard Yaka
Posts: 998
Joined: Wed May 17, 2006 12:00 pm
Location: Christchurch City, In front of the computer

Re: 5mge farting and missing( HELP)

Post by Steve_t647 »

"temp just got up there so i turned the truck off"
Sounds like it was running lean

"when i started it back up it was farting missing and not reving out the drive back was shit like it had droped a few cylinders"
Sounds like an airflow meter issue check the connectors, plugs and wiring check the earths too
Legal disclaimer: Any information I may have provided is worth exactly what you paid me for it.
User avatar
monaro427
Hard Yaka
Posts: 492
Joined: Sat Jun 18, 2005 12:00 pm
Location: where i want

Re: 5mge farting and missing( HELP)

Post by monaro427 »

well started it up after lunch and guess what it started idled and rev'd sweet as no probs so i let it idle until the temp got up to it's normal temp and guess what started to surge and play up but while it was cold good as gold so once it is hot thats when it all goes to custard farting and surging :x any other ideas to sort this prob out otherwise it might be heading into the shop :(
User avatar
Smurf
Hard Yaka
Posts: 2867
Joined: Tue Mar 04, 2003 12:00 pm
Location: Nelson

Re: 5mge farting and missing( HELP)

Post by Smurf »

I'd be guessing temp sensors then?
philux
Hard Yaka
Posts: 404
Joined: Sat Oct 28, 2006 12:00 pm
Location: Kaiapoi/Christchuch

Re: 5mge farting and missing( HELP)

Post by philux »

I had a very similar problem with my 2jz, did excatly the same as yours, ran like shit when it got hot, turned out it was damp in the valley where the plugs were, as it got hot the damp air turned to steam and the spark was shorting out, couldnt see any water or steam when the problem happened, I just got in there with a bit or crc and it soon came right.
User avatar
Jafa
Hard Yaka
Posts: 1307
Joined: Mon Nov 01, 2004 12:00 pm
Location: Katikati

Re: 5mge farting and missing( HELP)

Post by Jafa »

Idle Speed Control valve is seized?
'85 Hilux crawler, 3rz, duals, 4.7's, 4.88's, ARB's, 30 spline Longfields, 6 stud SNR4x4 Histeer, Airshocks up front, coiled rear, 40" Iroks.
^^^this shite is all about to change....^^^

021 273 9942
jafa@inspire.net.nz
User avatar
monaro427
Hard Yaka
Posts: 492
Joined: Sat Jun 18, 2005 12:00 pm
Location: where i want

Re: 5mge farting and missing( HELP)

Post by monaro427 »

cheers jafa i have actually been lookin into that just got to figure out where it is and if it is easy to get at :)
User avatar
Gaza
Driver/Navigator
Posts: 47
Joined: Mon Oct 20, 2008 1:13 pm
Location: Palmerston North

Re: 5mge farting and missing( HELP)

Post by Gaza »

hi i had the same problem with my one i found out i had build up on the contacts on my air flow meter once i cleaned them up it ran well again gaza
User avatar
MATT4U
Hard Yaka
Posts: 1306
Joined: Thu Sep 01, 2005 12:00 pm
Location: Waikato
Contact:

Re: 5mge farting and missing( HELP)

Post by MATT4U »

the temp sensors on those things are known for causing funny probs, warm it up, when its missing hee are 2 plugs up bt the water outlet, un plug them 1 at a time.
User avatar
Heath
Hard Yaka
Posts: 3297
Joined: Thu Dec 12, 2002 12:00 pm
Location: Rolleston, Chch

Re: 5mge farting and missing( HELP)

Post by Heath »

Dont the ECU's in a closed loop while engine warms up (ignore the AFM) and then apply the right mix etc from then. Perhaps a dirty/faulty AFM or oxy sensor in the exhaust.

Dunno just guesses from me.
Heath
Post Reply

Return to “Petrol Engines and Modifications”