fitting a 410 transfer case to 413

[zuknut]

Hi, I have a transfer case out of a flatdeck 410 truck, an when I went to put it in my 413 I found the bolts didn,t line up from the flangers to the drive shafts. Can I just redrill these? I tryed to change flangers over but the shafts are different sizers. I been told that 410 transfer c, is the lowest you can get without mods. How much lower than mine will that be? My 413 is registered, has 1600 motor an runs 31 in tyres, Any help much appreciatered. thanks

[zuknut]

cheers Chris, an no it doesent have the swith. Also looking at buying a lockright 4 rear, is there a cheaper place to get them than trade me? are they any good? They want $575 4 one on T M. thanks