94 Pajero bull bar with winch mounting wanted

[malfunction]

Anything considered

[malfunction]

*BUMP*

[TJared]

Any use?
http://www.trademe.co.nz/Trade-Me-Motor ... 591268.htm


from 2002 - dont know my pajeros to comment on if it would be easily adapted?
I have a mate could make something would look similar for similar price
But.. would need to measure up your vehicle in sth akl

[malfunction]

Any use?
http://www.trademe.co.nz/Trade-Me-Motor ... 591268.htm


from 2002 - dont know my pajeros to comment on if it would be easily adapted?
I have a mate could make something would look similar for similar price
But.. would need to measure up your vehicle in sth akl

yeah i thought about that one, but the 2002 onwards dont have full chassis like older ones apparently.
But thanks heaps for thinking of me, much appreciated

[malfunction]

*BUMP* Anyone?

[madmatt]

Hens teeth!!

[malfunction]

Hens teeth!!

Yeah I know, but gotta try. I even emailed the ARB guy in Palmy, but obviously such a low concern he didnt even bother to reply to me.

[wopass]

best to ring the guy in palmy mate.

[malfunction]

best to ring the guy in palmy mate.

Nah I emailed, if he cant be bothered replying thats fine. Im sure ill find one elsewhere

[tga_4x4]

best to ring the guy in palmy mate.

Nah I emailed, if he cant be bothered replying thats fine. Im sure ill find one elsewhere

Me too been there done that...

[malfunction]

best to ring the guy in palmy mate.

Nah I emailed, if he cant be bothered replying thats fine. Im sure ill find one elsewhere

Me too been there done that...

I find it easier to order my arb gear from Australia now. Cheap too. Just got a ez deflator for $60

[northland_pajero]

I have a 94 pajero with alloy bar, I used a winch plate between the chassis rails at the front, the winch is tucked up just in front of the lower radiator, comes out through the lower part of the bull bar but not attached to it

[malfunction]

Could you please email pics to rcnut@quicksilver.net.nz

[northland_pajero]

I dont have any pics of it apart.

What I did was get a winch plate and mounted it behind the bumper brackets on the chassis rails, there are two captive bolt holes that go from the top to the bottom of the chassis rail for the back of the plate.
I had to cut the front corners of the winch plate to make it fit behind the bumpr brackets then bolted a brace between the chassis rails to the front of the winch plate, alloy bar (or standard bumper) goes straight ontopyou just ned to cut the lower front fro the fairlead to fit though and a hole to operate the freespool (I havent cut the hole for the free spool, I winch out instead)