Firewall hole.

[Dr Rocket]

Can anyone tell me the best place to drill a hole in the firewall to run my boost hose and EGT wiring?????Photos if possible.

[NJV6]

Why don't you use a hole that is already there? They will fit through the rubber grommets beside the other wiring.

[kbushnz]

As suggested use an existing hole, my truck is an auto, but there was a hole with grommet in it for the clutch cable.
Or you can piigy back with an existing loom.

Cheers
Calvin

[niblik]

drill a new feckin hole...

[Dr Rocket]

READ THE QUESTION!!!!

[lincooln]

READ THE QUESTION!!!!

angry australian much?

[Dr Rocket]

Ex Whangarei.

[NJV6]

READ THE QUESTION!!!!

GET UNDER THE DASH AND DRILL A HOLE THEN!

[niblik]

READ THE QUESTION!!!!

GET UNDER THE DASH AND DRILL A HOLE THEN!

i did.

NJV6 - exactly...

in a new position. a location where it'll go to the back of the gauge easiest.

[Sadam_Husain]

READ THE QUESTION!!!!

Yeah drill it through the firewall mate

[lincooln]

Ex Whangarei.

Well thats better than being Australian.

[chevrolux]

preferably drill some where there isnt anything in the way

[kbushnz]

Sorry for the confusion....
If you need a hole I have a spare...
Help yah self.



Cheers
Calvin

[Dr Rocket]

How much do you want for that hole???

[kbushnz]

Its a spare mate, you can have it for free....
Just copy the picture and save to your HDD, print it out later.



Good luck with the hole placment. I had an expert drill a hole thru my Aircond once when he was fiting an alarm system to my car....
Somehow it was my fault because the other cars he had done were fine.

[darinz]

Its a spare mate, you can have it for free....
Just copy the picture and save to your HDD, print it out later.



Good luck with the hole placment. I had an expert drill a hole thru my Aircond once when he was fiting an alarm system to my car....
Somehow it was my fault because the other cars he had done were fine.

I think you miss the point.
Aircon works by the fact that as a liquid expands into a gas it cools down. Now by drilling the hole in the system, the alarm tech was actually allowing the gas to expand to a greater degree.
Logic would then state that he has actually improved you aircons efficiency

[Shane]

Its a spare mate, you can have it for free....
Just copy the picture and save to your HDD, print it out later.



Good luck with the hole placment. I had an expert drill a hole thru my Aircond once when he was fiting an alarm system to my car....
Somehow it was my fault because the other cars he had done were fine.

I think you miss the point.
Aircon works by the fact that as a liquid expands into a gas it cools down. Now by drilling the hole in the system, the alarm tech was actually allowing the gas to expand to a greater degree.
Logic would then state that he has actually improved you aircons efficiency

[Dr Rocket]

Would it make a difference if the hole he drilled was in the engine bay or the cab?????

[badnuz]

if you want it done properly send the firewall over to NZ and we will drill the required hole in a location we think is most suitable and then return it to you

[rangimotors]

one of these is the ticket, no drilling required.
http://www.youtube.com/watch?v=P5_Msrdg3Hk

[badnuz]

thats very clever

[Dr Rocket]

I have removed the firewall this evening but I will have to wait until I sell quite a few softdrink bottles to pay for all the stamps to post it to NZ. Unless I can get someone to take take it back as hand luggage.

[corosafari]

Thinking about doing the same thing, maybe we could swap firewalls, it will save on postage sending only one way. I knew my degree would come in handy.

[darinz]

Would it make a difference if the hole he drilled was in the engine bay or the cab?????

Now you are being just plain stupid. The piece of tube is going from the engine to the gauge so you have drill it from the engine bay or else the hole will be in the right direction!

Too much WA sun for you I think