Vitara front tow point
Vitara front tow point
Does anyone how to set up a good tow point on the front of a Vitara? My rear factory tow point has almost parted company with the chassis and the front won't bo to far behind if I get any more pulls.
Re: Vitara front tow point
I had a discussion with Neil Fraser when I went round to do my certification, What I was thinking for the front of mine was to drill out the two mounting points for the front bumper to the OD of some 12mm ID pipe, drill through the other side of the chassis (12mm), insert a crush tube through the chassis, then bolt some strengthening plates to that. Neil said it would be fine as long as I don't start welding to the chassis.
A bit hard to explain, but basically I want to run bolts through tubes through the chassis so it doesn't crush when I torque the bolts.
A bit hard to explain, but basically I want to run bolts through tubes through the chassis so it doesn't crush when I torque the bolts.
Re: Vitara front tow point
For the rear I just use a shackle through the tow bar tongue, tow ball removed.
Re: Vitara front tow point
Here is a good front tow point. Think he’s got a truck recovery hook bolted to the tow bar. Also for sale. Nice bloke to. http://www.trademe.co.nz/Browse/Listing ... =338041839 Cheers MIKE.
Re: Vitara front tow point
I would pm puddlejumper, He used to have a Vitara and had a nice setup on the front.
Lubrication Specialist
Lubrication Engineers
www.lubeng.com.au lincoln@lubengnz.co.nz
Lubrication Engineers
www.lubeng.com.au lincoln@lubengnz.co.nz