Vitara crown/pinion into Samurai?

[suzookyman]

Ok, have read a thred about this but I have a question, do I need a front and rear? or two fronts from a Vit/Escudo.
Cheers Al.

[UBZ]

Front 3rd member from a vit will bolt striaght in , think from memory that you have to change the side gears for the front axles.

However I would be inclined to install the vit ring and pinion into a samy steel housing instead if the alloy vit one, to do this you need a retianing rIng/ can to retian the side gear shalfts as the vit ring is larger than the samy one

Hope this makes sense, heaps if info on Aus zookers and Zuki world .

[Rotazuk]

As ubz you will need to front diffs . I am pretty sure most diff's you will find will be 22 spline , later ones are 26 spline . This is in the side gears .

The vitara carriers are only 2 spider , I think all 413's are 4 spider and samurai rear are 4 and front 2 .

The ring gear is thinner in a vitara so the carrier is moved over when installed in a 413/samurai housing . I brought in a kit that had the spacer and retaining ring , seemed to go in ok . Next time I may try the budget way , penning the holes where the pinion shafts go in . If you need a better explanation let me know . Have pic's somewhere when I did mine .

Cheers
Chris

[zukmeista]

Hey Al, sounds like you need this:http://www.lowrangeoffroad.com/suzuki/samurai/differentials/carrier-pin-retaining-cans.html Lots of other cool stuff on that site too.

[suzookyman]

Hey Al, sounds like you need this:http://www.lowrangeoffroad.com/suzuki/samurai/differentials/carrier-pin-retaining-cans.html Lots of other cool stuff on that site too.

Yeah, just got to find another front diff but you know me I'll find one...........these bloody Suzukis just keep following me home

[zukmeista]

I've got room if you want; but that depends whether you want it back . You mean a vitara diff?