Howsit everyone im running a A15 datsun 1600 motor and a 4 speed manual box in my suzuki sj410 and i used to be able to get the clutch to engage, recently replaced the clutch realease bearing or spiggot bearing as they say? and now i find that the bearing isnt pushing the pressure plate right in. like i cant get the clutch leaver to go all the way in.
Anyone know anythng that might help me out? its a bit frustrating! cheers!
A15 Datsun Clutch wont engage.
Moderator: Mark
Re: A15 Datsun Clutch wont engage.
Anyone? please. Any help at all?
-
Crash bandicoot
- Hard Yaka
- Posts: 2924
- Joined: Thu Dec 30, 2010 7:19 pm
- Location: Towing a hilux
Re: A15 Datsun Clutch wont engage.
1: your clutch plate is around the wrong way
2: the clutch fork is not seated on its pivot point properly
3: the pressure plate prongs are not strong enough
4: the master cylinder on vehicle is not large enough to fully thrust slave from donor gearbox forward/back/sideways enough to disengage/ engage the clutch when you first did the transplant.
Now with a new parts you may need to make an adjustment rod to go between the slave and the clutch fork.
could be many things
2: the clutch fork is not seated on its pivot point properly
3: the pressure plate prongs are not strong enough
4: the master cylinder on vehicle is not large enough to fully thrust slave from donor gearbox forward/back/sideways enough to disengage/ engage the clutch when you first did the transplant.
Now with a new parts you may need to make an adjustment rod to go between the slave and the clutch fork.
could be many things
Waiter...there is a drought in my glass.