eliptcial spring into a Terrano

[long]

Has anyone one on the message board done this mod to a terrano if so Im me me or e mail longnitemals@gmail.com.
Im looking at doing it to my 2 door one so i can get more hight n bigger round black things under it.
TNX in advance.

[DieselBoy]

Have you ever stuck your head under your Terrano and had a look at what sort of springs it has??

I think you will find the rear is coil sprung and the front is torsion sprung.

Either that or you have a very rare leaf sprung model??

If so, what sort of eliptical springs where you thinking??

You can get the following:

3/4 eliptical

1/4 eliptical

Full eliptical

What were you thinking??

[long]

I sure have had my head under the old girl n yup you r correct with the suspension system it has under it.
Im thinking of useing the likes of dare i say it cause i will have to go was out my mouth with soap toymota front n rear diffs with there orignal spring system so i can get some decent hight out of the beast because the orignal system sux big time for lifting it up.

[SMOKEY]

Hi Long, when you ask about fitting Elliptical Springs, do you mean to the front to replace the torsion bar set up ??. If you look in Forums, Projects/Mods 3/4 down first page kbjj (Jeremy) has a build thread of his Navara showing what can be done. You already have coils on the rear that I am sure with a bit of tuning can be made to work better. As you will see in Jeremy's build it's not cheap but he has a very capable vehicle mind you he is a very capable Electrician that is not bad as an Engineer , mind you he was taught by NIBBZ ,just didn't inherit his slow build genes . And as NIBBZ would say,

CHEEKY FAWKER,

FITZY.

[long]

Giday smokey im thinking more of replaceing both ends with them im tired of coils n torsion bars