ln106 solid front axel with 33s or 32s???? (standard height)

boydos · Post by **boydos** » Mon Apr 18, 2011 10:06 pm

looking 4 some bigger tyres for the lux, 31s bit little. will i get away with 33s at standard height??? or will 32s be better??? also geetin some new 15x8 rims 4 the tyres so what offset is better 4 sfa hilux???

cheers guys

btw not doin any major 4wd just forestry roads and the odd bully track while hunting.

GotFlex · Post by **GotFlex** » Mon Apr 18, 2011 10:09 pm

yip its possible, did on amates truck, redrilled the spring leaf hole 30mm forward to push diff housing forward and then used the same drag link but flip it around the other way.

rangimotors · Post by **rangimotors** » Mon Apr 18, 2011 10:12 pm

get some new 31's. I have run 32's at standard height but they were worn and did rub a fair bit. A friend with the same truck with new 31's with a good bite on the edge's went more places than i did. Look at tyre choice and measure them, 31's of the shelf range from about 29-31.5 depending on brand etc and are cheaper by a long way than 32's that are not so common.

or give it a cheap lift and chuck some bigger feet on it.

boydos · Post by **boydos** » Mon Apr 18, 2011 10:32 pm

too much guys, still want to go bigger though just want to know what off set to get on the rims and wether 33s will fit. Lift mite have to wait 4 a bit, tyres dear enough!!!!

GotFlex · Post by **GotFlex** » Mon Apr 18, 2011 10:36 pm

15x8 -28 offset will be sweet with 33s, the other ive seen done was lift shackles, helped push diff forward and bit more clearance for tires

bigboar357 · Post by **bigboar357** » Tue Apr 19, 2011 12:20 am

i run 31 on my hilux wen hunting and they hit the gards wen ya climbing out of a rut some times.and i got a 2inch lift in the front

boydos · Post by **boydos** » Tue Apr 19, 2011 9:41 pm

Where do u find lift shackles mate??????

gimmemud · Post by **gimmemud** » Wed Apr 20, 2011 12:50 am

boydos wrote:Where do u find lift shackles mate??????

http://www.4wdbits.co.nz/ProductsList.a ... egoryID=30

ln106 solid front axel with 33s or 32s???? (standard height)

ln106 solid front axel with 33s or 32s???? (standard height)

Re: ln106 solid front axel with 33s or 32s???? (standard height)

Re: ln106 solid front axel with 33s or 32s???? (standard height)

Re: ln106 solid front axel with 33s or 32s???? (standard height)

Re: ln106 solid front axel with 33s or 32s???? (standard height)

Re: ln106 solid front axel with 33s or 32s???? (standard height)

Re: ln106 solid front axel with 33s or 32s???? (standard height)

Re: ln106 solid front axel with 33s or 32s???? (standard height)