hilux 3wd prob

[toymudlux]

have a yn65 that has lockrites front and rear for a while and the front right now dosnt turn under power but the left is still pulling hard , am not the sharpest tool in the garage when it comes to these things ,am thinking its probably the manual hubb ??
need some advice from you clever/sharper blokes ???
and if any one has hubbs for sale ..
are there any brads to stay away from ??
cheers Andy

[JTop]

could also be a cv or axle.
The only brand worth having are Aisen, get it/them 2nd hand from a wrecker
J Top

[NJV6]

Jtop, got any 28 spline Paj Aisin FWH's up your way?

[mike]

Yup I did mine just recently. Dont know the models so well but mine is IFS and it was the CV shaft shearing just before the spline that goes into the hub.

Mike

[JTop]

No im looking for a set for my L200
J Top

[Clint]

Pull the cap off the hub & you'll see if it's buggered. More likely to be a CV or axle shaft, especially on the right side of a lockered hilux.

Given that it's still spinning I would guess inner axle shaft. The short side is a known weak link. You could replace it with a strengthened one from Howatt Engineering in Wellington & genuine CV's are only about $80

Cheers
Clint

[Steve_t647]

Ditto above, if you are going this far it may also be a good time for kingpin bearing replacement this takes a little while.

Took me 3 hours a side Kingpins

I think I will be quicker next time and I am putting the rear LSD into the front (when I have the money).

[toymudlux]

sweet thanks guys , will wait for fine weather and go pull it apart and have a look , did the king-pin bearing a couple of months ago..

[SupraLux]

Or bring it with you Sat morning when/if you come out and we can whizz the cap off and have a look

Steve

[toymudlux]

will be out tommorrow and will bring lux for a stroll ..
will give you a call when on the way out ...(will need address)
cheers Andy