Oh dear - major cock up - flywheel machining wellington

[mike]

HI All,

Anyone have a lathe that can grip 380mm? I may have sheared the key off and scored the bajeesus out of the taper on the flywheel twice

I need to take out 0.1mm or 0.2mm out of the taper on the flywheel to clean it up and try and make the keyway nice again. Anyone have access to an old(or new) lathe that can handle this worth couple of boxes of the good stuff at least

we all love to help an idiot out

[mercutio]

i know where there is a decent size old lathe but it is in tokoroa

[SMOKEY]

Hi Mike, I could help out if you are in CHCH , but Wellington could be a bit tricky unless the ORE courier system could kick in ????. . You have done a few taper fits , to know if there not spot on ,

SHIT HAPPENS,

FITZY.

[mike]

Hi Mike, I could help out if you are in CHCH , but Wellington could be a bit tricky unless the ORE courier system could kick in ????. . You have done a few taper fits , to know if there not spot on ,

SHIT HAPPENS,

FITZY.

could be an option anyone heading south?

[niblik]

Hi Mike, I could help out if you are in CHCH , but Wellington could be a bit tricky unless the ORE courier system could kick in ????. . You have done a few taper fits , to know if there not spot on ,

SHIT HAPPENS,

FITZY.

ditto to this...

[Jafa]

Drop me a line Mike, [in best John Wayne voice] "I'll fix yur wagin"

0212527201

[mike]

look who has popped out of the woodwork - ole jafa hope you realise, it aint gonna need 82" of travel