1kz-te front mount.

[klompy]

Hi I am going to do a front mount and think an intercooler 450x150x65 will fit best down low were I want it to go,will that size be to small to big or ok,thanks.

[DDAN]

Have a quick search as this as been covered as a lot of guys have already done it

[klompy]

Thanks Dan have searched but did'nt much on how to size them.

[Jerry]

this shou;d bolt straight on

http://www.trademe.co.nz/Browse/Listing ... =477017173

[klompy]

Thanks Jerry but don't want top mount and they are not very cheap.

[DDAN]

Just go with a 300x280x75 I've got one on my 1kzt it's bit of an over kill rated for enough flow to 500 hp but works well

[strx7]

Hi I am going to do a front mount and think an intercooler 450x150x65 will fit best down low were I want it to go,will that size be to small to big or ok,thanks.

it'll be fine, i ran a 450x180x65 on my 4.2 cruiser for over 2 years.

[klompy]

Thanks strx7.

[BigBertha]

if ya havent sorted it out yet and need some info. i run a custon intercooler setup using a nissan avenir sr20det intercooler, seems to work quite well, ive gone top mount on mine, there is a little boost lag but dont notice it in 4x4. only got it for 50 aswell so im happy with it.

[Sheepy]

Could you chuck a couple of pics up? I have a couple of r32 skyline ones sitting here I am going to try and adapt into a top mount.

[BigBertha]

yea man, il try and get some good pics tomorrow for ya.my setup is abit hory, wont win any awards but does the job well.

[BigBertha]

this is my setup.