Safari auto trans or manual conversion

[Chewy69a]

Hi All,

My trans has died so looking for a good second handy one or even a manual conversion.

gearbox
flywheel
clutch
clutch fork
pedal
master cyl and booster
slave cyl and line
gearbox mount -are these the same for an auto / manual?
driveshafts -are these the same for auto and manual?
rubber shifter boot

Any help appreciated.

[mayday]

Ive got an auto here in auckland in good condition $400

[tga_4x4]

http://www.trademe.co.nz/motors/car-par ... 646785.htm

Pretty cheap for a 5 speed

[Chewy69a]

http://www.trademe.co.nz/motors/car-parts-accessories/nissan/gearboxes/auction-498646785.htm

Pretty cheap for a 5 speed

Yeah mate I've seen that -its me asking those questions for all the other bits, I'm a bit hesitant as they seem to indicate there is something wrong with it. Even so if it needs a set of bearings could be a good deal.

[tga_4x4]

http://www.trademe.co.nz/motors/car-parts-accessories/nissan/gearboxes/auction-498646785.htm

Pretty cheap for a 5 speed

Yeah mate I've seen that -its me asking those questions for all the other bits, I'm a bit hesitant as they seem to indicate there is something wrong with it. Even so if it needs a set of bearings could be a good deal.

http://www.trademe.co.nz/motors/car-par ... 656968.htm

[Chewy69a]

http://www.trademe.co.nz/motors/car-parts-accessories/nissan/gearboxes/auction-498646785.htm

Pretty cheap for a 5 speed

Yeah mate I've seen that -its me asking those questions for all the other bits, I'm a bit hesitant as they seem to indicate there is something wrong with it. Even so if it needs a set of bearings could be a good deal.

http://www.trademe.co.nz/motors/car-par ... 656968.htm

Ok so i scored it, went down wednesday and picked it up.

So who knows the spigot bearing size? Obviously i can measure the shaft but the crank is inknown until i pull the old auto out tonite and would like to get a bearing organised today. Can anyone help?

Also looking at replacing the front bearing in the gearbox just for luck.

[nismo26]

Can get them from Nissan or here
http://www.trademe.co.nz/motors/car-par ... 872585.htm

[tga_4x4]

When i did my conversion there was already a brass spigot in the crank