Hey guys I'm about to replace the radius/diff bushes in the front of my y60 safari.
It's only used to pull the boat and my fat ass to work so my question is do I go genuine or aftermarket and is there anyone you recommend to purchase these from?
Cheers all
Radius bushes, which ones to use?
Moderator: Mark
Re: Radius bushes, which ones to use?
Standard ones are best after are soft and will not give the standard feel your used to
But are not cheap off Nissan over here
But are not cheap off Nissan over here
89 safari, pto winch, 33x15 simexs. sliders,75mm lift . turbo intercoolered
Re: Radius bushes, which ones to use?
Hmmm righto off to get bent over then......
Re: Radius bushes, which ones to use?
Get the Toyota ones off Suzolla cheaper than Nissan and still fit, don't get the cheap ones they #### out real quick,
Re: Radius bushes, which ones to use?
???? Toyota ones? Same same?
Re: Radius bushes, which ones to use?
Yep Toyota ones, pm Suzolla I got some off him for my Safari.
Re: Radius bushes, which ones to use?
80 Series Landcruiser ones are the same I beleive. Dont get Nolathane either, doesnt last long...

027 MUD GEAR - (027 683 4327)
Check our facebook:
http://www.facebook.com/Filthy4x4
http://www.facebook.com/Filthymotorsportnz
Re: Radius bushes, which ones to use?
Ahhaa awesome!!
Re: Radius bushes, which ones to use?
Thanks for that nismo.
Gren, yes still got some.
Cheers
Tim
Gren, yes still got some.
Cheers
Tim
Re: Radius bushes, which ones to use?
Cheers Suzolla.
Hey while you're all here, anyone had those caster adjusting bearings put in their trucks?
I'm determined to get this thing driving straight and have seen these things mentioned a few times on the Aussie site.
Hey while you're all here, anyone had those caster adjusting bearings put in their trucks?
I'm determined to get this thing driving straight and have seen these things mentioned a few times on the Aussie site.
Re: Radius bushes, which ones to use?
Do you have a problem with the castor at the moment?
Re: Radius bushes, which ones to use?
Yeh it is set back 1 degree on the left.