1HDT Crankshaft wanted

[Ben]

My 1HDT has run a big end bearing and my crank is no good for the rebuild, so I'm looking for a replacement.

Would consider one that needs regrinding if anyone has one kicking round or knows of someone that might have one.

Ben

[Trundle]

lineside 500 plus gst or new form toyota 1000 plus gst ,
Or a nissan td42 motor is 1000 complete. hehehe ,
Make sure you replace the rod bolts and you will have to get the rod resized ,
Also from memory you cant get oversized bearings ?

[doddzee]

Ive got this sitting in wellington



It was rebuilt twice (poorly by a engine re conditioner in Wellington) then started excessively smoking at 130,000 km so it got pulled and replaced with a 24 Valve. Main bearings etc were all replaced at time of rebuild.

Ive taken the injector pump and turbo kit. Head, block, crankshaft etc all there. Will sell it for $500 and you will get a spare head.

[Ben]

lineside 500 plus gst or new form toyota 1000 plus gst ,
Or a nissan td42 motor is 1000 complete. hehehe ,
Make sure you replace the rod bolts and you will have to get the rod resized ,
Also from memory you cant get oversized bearings ?

Thanks. Lineside were out of stock when I called, and have drawn a few other blanks too. I was too scared to ring Toyota for a price!

ACL do undersize bearings in a few sizes. They have been low/out of stock but apparently have made more and they are on their way to NZ.

[Ben]

Ive got this sitting in wellington

It was rebuilt twice (poorly by a engine re conditioner in Wellington) then started excessively smoking at 130,000 km so it got pulled and replaced with a 24 Valve. Main bearings etc were all replaced at time of rebuild.

Ive taken the injector pump and turbo kit. Head, block, crankshaft etc all there. Will sell it for $500 and you will get a spare head.

Cheers, I'll shoot you a PM.

Ben