Shiney Axle Swap ;)

Starting a project or modification? Then post it's progress here and show us some pic's.
User avatar
Engineer
Hard Yaka
Posts: 550
Joined: Wed Mar 29, 2006 12:00 pm
Location: Invercargill

Re: Shiney Axle Swap ;)

Post by Engineer »

pruggerdore wrote:just found read whole thread. WELL DONE,good effort

thanks was a huge learning curve!

surf10 wrote:for a shiny truck it went well. even did better than a couple of lexus hiluxs aye rayn lol :mrgreen:


:lol: i owned them!
the commy with 35" tires & 4.875 diffs is a great combo.
Thats why u need to get the big brother of me engine!
LN130 Surf: Coiled SAS, 35" BFG M/T's, Lifted, Rear Lockright, Snorkel, CB, On-board air
Soon to be 3.8 commy powered, front ARB Air Locker, custom bar work, winch...
User avatar
NJV6
Hard Yaka
Posts: 2751
Joined: Mon Nov 15, 2004 12:00 pm
Location: Southland

Re: Shiney Axle Swap ;)

Post by NJV6 »

Paj -1
Surf - 0
SWB V6 Paj with one or two mods ;)
User avatar
Engineer
Hard Yaka
Posts: 550
Joined: Wed Mar 29, 2006 12:00 pm
Location: Invercargill

Re: Shiney Axle Swap ;)

Post by Engineer »

NJV6 wrote:Paj -1
Surf - 0


if the paj gets 1 point due NOT going thru the hole i dug (which eventually i didnt get out of) when towing out all the nissans then thats hardly fair! I think i get a point for putting a show on though!

However if the paj gets 1 point for fuel consumption then thats a well earned point lol
LN130 Surf: Coiled SAS, 35" BFG M/T's, Lifted, Rear Lockright, Snorkel, CB, On-board air
Soon to be 3.8 commy powered, front ARB Air Locker, custom bar work, winch...
User avatar
surf10
Hard Yaka
Posts: 139
Joined: Mon Sep 21, 2009 9:40 pm
Location: Invercargill

Re: Shiney Axle Swap ;)

Post by surf10 »

dont worri ryan, he still drives a paj :mrgreen:
Hidemylux
Newbie
Newbie
Posts: 1
Joined: Sun Nov 17, 2013 6:34 pm

Re: Shiney Axle Swap ;)

Post by Hidemylux »

Hi Engineer
I'm new here and have been looking at sas kits for hilux,s. I have 2001 dbl cab that regularly blows cv,s 3 this year, the last was yesterday at waikawa rally grounds. So I'm needing advice ,help, someone who can weld etc any assistance would be much appreciated.
Post Reply

Return to “Projects / Mod's”