Can you grease Y60 swivel hubs without disassembling?

[Slideways]

Hey guys,

Coming from a 70 series Landcruiser where you are able to grease the swivel hubs by removing a bolt and filling with a grease gun. I can't see anything like this on my new-ish Y60 Safari?

Can it be done or does the whole thing need to be pulled apart?

Maybe remove a bolt and fill with grease or even retrofit a grease nipple?


Cheers

[mudlva]

Remove the wipers and apply grease then refit wipers again.
Imho Its a design cockup from nissan

If you are going to drill and tap then you will need to remove the complete hub

[muddy]

Remove one of the kingpin bolts - grease-gun fits nicely in the threaded hole. It takes a full tube of grease to fill the hub...

[Slideways]

Awesome thanks guy, will sort out asap. Just another thing on the list giving the Safari a bit of a birthday (and cert).

[mudlva]

Remove one of the kingpin bolts - grease-gun fits nicely in the threaded hole. It takes a full tube of grease to fill the hub...

arhh this is why this site is so good ,

i knew there was an easier way then my my but hadnt worked that one out

[CLUMZ1]

pix or GTFO? I'm a complete mechanical noob and have no idea what a kingpin is. Cheers (from the computer nerd)

[muddy]

4 bolts holding a flat plate top & bottom of the swivel hub. The top ones include the steering ball-joints. I usually remove one of the bottom ones so any water can drain, although if your inner axle seal is leaking then be prepared for a fair bit of mushy mix of gear oil & grease to land on the driveway. The bottom ones are also easier to access without brake lines & steering joints in the way...

[CLUMZ1]

Ah yep that rings a bell (from the service manual I have) thanks.

[Swamped]

Remove one of the kingpin bolts - grease-gun fits nicely in the threaded hole. It takes a full tube of grease to fill the hub...

Thanks for that

[shortylux]

arhh this is why this site is so good

X2.

Thanks Muddy.

Get those bumps Slideways?

[Slideways]

arhh this is why this site is so good

X2.

Thanks Muddy.

Get those bumps Slideways?

Yep got them last night Much appreciated! I'll fit them once my new shocks arrive which should hopefully be today, which means I'll get them tomorrow since the courier will be scared of the dog

[Fakey]

The king pin plates can easily be drilled an tapped for a small grease nipples
like this:


there are plastic seals under the king pins that i drilled 4 small holes in to let the excess grease into the swivel hub

[taz01]

Remove one of the kingpin bolts - grease-gun fits nicely in the threaded hole. It takes a full tube of grease to fill the hub...

From memory if its never had the kingpin bearings replaced the above wont work.....they have a blanking plate from factory you have to remove these to replace outer bearing once gone then the above works

[Fakey]

Yes that's what I was talking about, I put mine back in to keep the grease in the kingpin bearings but drilled 4 small holes in them to let some grease into the swivel hub