Is there an easy way to determine if my front diff has a bent knuckle?
Wheel alignment only tells me the left side is 2degrees back from the right.
Safari front knuckles
Moderator: Mark
- mudlva
- Hard Yaka
- Posts: 2918
- Joined: Mon Apr 16, 2007 12:00 pm
- Location: fixing another cv!! dam lockers (Papakura)
Re: Safari front knuckles
Check the radius arm rear bushes first as if the bush is worn then that side will be further back than the other side
Re: Safari front knuckles
Done that and swapped out the old diff/radius arm bushes also. Along with putting in another pair of radius arms.
Re: Safari front knuckles
Usually pretty obvious by looking directly at the front of the vehicle and eye balling the front wheel camber.
Re: Safari front knuckles
The camber is fine it's just the caster that's giving me the headache
Re: Safari front knuckles
Oil seal leaking at all 
That's a good sign

That's a good sign
89 safari, pto winch, 33x15 simexs. sliders,75mm lift . turbo intercoolered
Re: Safari front knuckles
Actually yes it is, the driver side is leaking.possible that this one has been bent forward ?
Re: Safari front knuckles
bent forward, that's a good trick , bent mine from bouncing the front up to high
$130 for bare axle housing , superior reinforcement kit seems to hold up now.
theres some guy on trademe selling complete reinforced axle housings
$130 for bare axle housing , superior reinforcement kit seems to hold up now.
theres some guy on trademe selling complete reinforced axle housings
89 safari, pto winch, 33x15 simexs. sliders,75mm lift . turbo intercoolered
Re: Safari front knuckles
Heh, ya maniac!
Me and my truck are all about towing the boat to the water and back.
Spose I should strip the housing and run a long straight edge across the face of the pumpkin then measure forward to the knuckles to check for bendy bendy.
Me and my truck are all about towing the boat to the water and back.
Spose I should strip the housing and run a long straight edge across the face of the pumpkin then measure forward to the knuckles to check for bendy bendy.
- mudlva
- Hard Yaka
- Posts: 2918
- Joined: Mon Apr 16, 2007 12:00 pm
- Location: fixing another cv!! dam lockers (Papakura)
Re: Safari front knuckles
Gren wrote:Heh, ya maniac!
Me and my truck are all about towing the boat to the water and back.
Spose I should strip the housing and run a long straight edge across the face of the pumpkin then measure forward to the knuckles to check for bendy bendy.
And just remember yo leave the goats alone

A few questions
How does the steering feel? Pulling to one side or straight and true
What us the tyre wear like? ripping one tyre apart or maybe both
If the steering is fine and tyre wear std then i would suggest leaving well alone. Many older vehicles end up with different measurements from one side to the other and fir many different reasons as well
Re: Safari front knuckles
Love them goats!
Tyre wear is fine, vehicle pulls left which is the only reason I'm going down this path as it's rather bugging me on long trips.
I'm determined to get this thing driving straight if it damn near kills me.
Tyre wear is fine, vehicle pulls left which is the only reason I'm going down this path as it's rather bugging me on long trips.
I'm determined to get this thing driving straight if it damn near kills me.
Re: Safari front knuckles
think you have to do drive off a cliff for a safari to kill you 

89 safari, pto winch, 33x15 simexs. sliders,75mm lift . turbo intercoolered
Re: Safari front knuckles
Don't tempt me........