VR 3.8 v6 - What Wiring..

[NB42]

So am putting a 1994 vr 3.8 into an isuzu wizard and was wondering how people have wired theirs in conversions to make it run? I have looked around the web and havent been able to find any wiring diagrams or anything along those lines.. We have the full commodore so have the full loom but were aiming to join it into the ignition loom of the wizard. Will have a computer with the VATS removed as well. Any help is much appreciated. Cheers

[Ashohman]

Where are you I wired my conversion myself vt ecotec into my highlux. Not that hard. Could lend a hand if needed

[NB42]

I'm in hamilton. Just stuck on where to put power to and so on

[kbushnz]

Quick google search found this..
http://forums.justcommodores.com.au/att ... e-auto.jpg
Any help ?

[Ashohman]

Do u get how to read that diagram? And have you looked at what does what on you veichle? Loom? Going ng into engine bay just need to lable them myn was starter motor water temp oil pressure acc and that was about it but cab see on that diagram crash has shown what wires need to go where.