putting elockers front/rear in KZN185 surf - parts needed?

[floatingkiwi]

Hi Folks

I'm putting Eaton/Harrop elockers in my truck, front A11167 and rear A9334, and would like any hints or things to remember from you guys.

Also, should I get new bearings/seal kits from Terrain tamer (or anyone else) for each diff? Are the bearings destroyed when doing the job?

Anything else I should do?

[coxsy]

may as well give it new bearings, it's common to do so when putting a locker in

[lax2wlg]

Yep and solid pinion spacer, get rid of that crush sleeve. Its going to need replacing anyway, may as well upgrade to Solid spacer to avoid the possibility of preload getting slack and ultimately munching your r&p

[floatingkiwi]

where's the best place to get this stuff from folks?

[coxsy]

bearings a bearing shop is a good start or you local toyo dealer maybe

[lax2wlg]

I used yotamasters.com and Trail Gear for Toyo diff stuff when in the US, however Im sure there are local options too. Try suzolla/4wdstuff here on ORE

[Clint]

Not sure on the Surf but I didn't need any extra parts to put the e-locker in my rear 80 series diff. I put in new bearings anyway along with a solid spacer, got a Terrain Tamer kit from Performance Mechanical in Taupo.

Cheers
Clint

[Trundle]

We can do the rebuild kits and E-lockers also if you have not got them yet ,