Question i got asked today..
revolving around r200 lsd coversion to the longer D22 front axles.
you have to disassemble the inner tripod joint and swap the 5 bolt flange cv onto your ale and cv
remove the inner tripod joint rubber boot on the d22 and then tap the cup down onto the axle, a seal will pop off exposing the tripod,
clean the grease off remove the circlip, then tap the tripod off the axle shaft.
![Image](http://static.nissan4u.com/epc_img/57452178288614.png)
part numbers 2.3.5.6.7 and 15 bottom left of image 5 bolt inner
wth the 5 bolt cv, remove the rubber boot /slide it down the axle, clean away the grease and you should see a large inner circlip that holds the race inside the cup, slide it out and remove the smaller circlip from the other side/end of the axle... tap bearing race off the axle and reassemble them onto the d22 axle.
IF the race wont budge from the cup of the 5 bolt cv cup, remove the cover over the end and do it the same way the tripod joint is done.