80 series rims on 185 surf

[mudsurfv6]

is anyone using 16" 80 series rims on 185 (maybe also 130 ) surfs?
I believe they have a different centre bore measurement, 80 series-110mm 185 surf-106mm.
is that right? does that matter?

[a80crewza]

I've been researching what rims would fit my 80 series. Limited info on it but found that the center bore on an 80 series is 106mm (not 100% sure though), i'll measure my hubs when have access to my 80. Also read that the later 80 series with 16" rims are 'hub-centric'.. which means the fit has to be right with the rims and the hub (ie, 106mm hub with a wheel with a 106mm center hole). Don't know if it matters much though. Some people say its important that you keep the rims hub-centric if they are like that from factory. I might be reading into it to much

Does anyone have the exact hub diameter of an 80 series or 185 surf?

[mudlva]

being that i have both models i went and measured

106mm rear hubs on both vehicles, 96/kzn185 & 96/vx80

[mudsurfv6]

106mm rear hubs on both vehicles, 96/kzn185 & 96/vx80

that makes it easy. thanks for that.

what length are the wheel nuts on the 80? looks like they have to go a long way inside rim, in a quite small hole. (standard 80 alloys).

[mudlva]

106mm rear hubs on both vehicles, 96/kzn185 & 96/vx80

that makes it easy. thanks for that.

what length are the wheel nuts on the 80? looks like they have to go a long way inside rim, in a quite small hole. (standard 80 alloys).

std alloy rims have deep walls. the studs would be about even as when i bolt the steel rims on there is similar length of stud protruding out of the nut once tight

[KIWI_TERRANO]

Mates got 80 factory alloys on his 185 running 285/75 16

[mudsurfv6]

got a set, thanks guys