Hi guys this has probably been asked before but was wondering what size pipe you are using to make rock sliders and bar work? Sick of worrying about damage.
Also what's the best way to attach rock sliders?
Cheers
what type and size pipe to use for bars?
-
Crash bandicoot
- Hard Yaka
- Posts: 2924
- Joined: Thu Dec 30, 2010 7:19 pm
- Location: Towing a hilux
Re: what type and size pipe to use for bars?
50Mm o/d 3 to 5 mm wall you can ubolt around the chassi rail, or sandwich the chassi rail with plates and bolts or drill through the chassi rail and bolt with crush tubes, if its jyst a bush hack weld it with a 100cm2 plate to spread load.
Waiter...there is a drought in my glass.
Re: what type and size pipe to use for bars?
Cheers man I'll order some up tomorrow
Re: what type and size pipe to use for bars?
I'm using 42mm od with 3.2mm wall.
Have my grandads old Bramley bender. The above pipe fits the 1 1/4 (I think) die well...steam tube size
Have my grandads old Bramley bender. The above pipe fits the 1 1/4 (I think) die well...steam tube size
modified surf, hardly drive it seem to keep modifying it....
Re: what type and size pipe to use for bars?
Same..skidmark wrote:I'm using 42mm od with 3.2mm wall.
Have my grandads old Bramley bender. The above pipe fits the 1 1/4 (I think) die well...steam tube size
