Driveshaft shop in Auckland?

[turoa]

Hi all,

I have recently swapped a 3.9 and auto into my 110 land Rover. Given that it had the Lt77 attached to a ld28 the rear driveshaft was too short with the new combo (front is standard disco item). I am now looking for a reasonably priced engineering shop in Auckland to rebuild the shaft.

In an effort to get it moving I made one the correct length out of a disco and my 110 item but given that it was a temporary one made on the floor it is not completely straight.

Can anyone recommend someone reasonably priced to either cut and straighten my shaft or retube the whole thing?

[mudlva]

Drive shaft specialist

Russell
092731532

32 Andromeda Cres
East Tamaki
Auckland
New Zealand

Been doing my d.s. for years good job and good prices compaired to betties

[turoa]

Awesome cheers will give him a bell!

[DieselBoy]

I've had a few shafts made for the Sals to disco axle swap at ATL in Hamilton if that's any help

http://www.atlbalancing.co.nz

[lilpigzuk]

you sure there isn't a factory length? Let me know and I will go through the shelf. you wouldn't of had the measurement the other day!

[turoa]

I've had a few shafts made for the Sals to disco axle swap at ATL in Hamilton if that's any help

http://www.atlbalancing.co.nz

Cheers man, Ill give them a bell as well

you sure there isn't a factory length? Let me know and I will go through the shelf. you wouldn't of had the measurement the other day!

Yep LT85 110 should have the correct shaft. Will flick you a message