Toyota Spares - How do I avoid getting ripped off ?
Toyota Spares - How do I avoid getting ripped off ?
I went to the Toyota dealer and got a price for the power steering control seals and was told that these are a discontuned part that sells for around $400 but that there wae a set sitting at another branch that they may be able to get for me at around $100
They also qouted $70 for the heater blower resistor unit ( the bit that gives the slower speeds)
The power steering controler is weeping a bit and is also making some noise when the wheel is turned.
I was told that replacing the seals will fix this ...
Any help as to where to get parts at the best price would be appreacated
They also qouted $70 for the heater blower resistor unit ( the bit that gives the slower speeds)
The power steering controler is weeping a bit and is also making some noise when the wheel is turned.
I was told that replacing the seals will fix this ...
Any help as to where to get parts at the best price would be appreacated
There is no mechanical problem so difficult that it cannot be solved by brute strength and ignorance.
- niblik
- Sausage Shack
- Posts: 3305
- Joined: Wed May 03, 2006 12:00 pm
- Location: erm.. out in the shed for a mo...
as for seals, i was with h20 when he did his power steerin pump..
from memory he bought 'after market non factory type' seals.. it leaked albeit ever so slowly.. then he went and got some factory style seals/seal and its been spot on ever since..
i dont know what the difference may be, if any,but for me, for peace of mind i'd go toyota dealer.. in that circumstance inhoo..
as they say, each to their own...
good luck..

from memory he bought 'after market non factory type' seals.. it leaked albeit ever so slowly.. then he went and got some factory style seals/seal and its been spot on ever since..
i dont know what the difference may be, if any,but for me, for peace of mind i'd go toyota dealer.. in that circumstance inhoo..

as they say, each to their own...
good luck..



Jerry wrote:$102 for a rear transfer case seal for my Rugger from Toyota, the Toyota ones are the best apparantly as they are made with the correct lips etc....
the random number generator cant have worked in your favour, cause i just got one from toyota for my prado and it was $37.80

toymota thats stock standard.
Re: Toyota Spares - How do I avoid getting ripped off ?
dazza85 wrote:I went to the Toyota dealer and got a price for the power steering ...
Any help as to where to get parts at the best price would be appreacated
You could try giving Just Cruisers a call in Ch-CH - aka Lineside Auto - on 0800 444 589
Baldrick
91 Cruiser VX Ltd Auto Diesel Turbo *Safari snorkel * 80mm RAW suspension lift * Custom Bull-bar * 33" MT tyres * 26Mhz & UHF CB units * West Coast Rust * And a partridge in a pear tree! Oh... and an awesome new Co-Pilot
91 Cruiser VX Ltd Auto Diesel Turbo *Safari snorkel * 80mm RAW suspension lift * Custom Bull-bar * 33" MT tyres * 26Mhz & UHF CB units * West Coast Rust * And a partridge in a pear tree! Oh... and an awesome new Co-Pilot

Beware of Lineside Auto.
Yes they do a good range of stuff but you sure pay for it...they are the most expensive wrecker in chch.
I recently needed to replace the bash plate on my 94 Hilux Surf.....
they were going to charge me $95 + GST = $106.88
I rang around & got one for $60 including GST from Falsgrave Auto.
sooo be careful.
Yes they do a good range of stuff but you sure pay for it...they are the most expensive wrecker in chch.
I recently needed to replace the bash plate on my 94 Hilux Surf.....
they were going to charge me $95 + GST = $106.88
I rang around & got one for $60 including GST from Falsgrave Auto.
sooo be careful.
-
- Hard Yaka
- Posts: 275
- Joined: Sun Dec 31, 2006 12:00 pm
-
- Hard Yaka
- Posts: 320
- Joined: Sat Aug 26, 2006 12:00 pm
- Location: Amberley / North Canterbury
niblik wrote:as for seals, i was with h20 when he did his power steerin pump..
from memory he bought 'after market non factory type' seals.. it leaked albeit ever so slowly.. then he went and got some factory style seals/seal and its been spot on ever since..
i dont know what the difference may be, if any,but for me, for peace of mind i'd go toyota dealer.. in that circumstance inhoo..![]()
as they say, each to their own...
good luck..
Im with Nibby on this,with seals Factory is the only way to go.
***Prior Preparation Prevents Piss Poor Performance***
Most sports require only one ball - real sports require two.
Most sports require only one ball - real sports require two.
gomulletgo wrote:they were going to charge me $95 + GST = $106.88
I rang around & got one for $60 including GST from Falsgrave Auto.
sooo be careful.
Bashplate? If that got shagged mate chances are it will probably do it again........You did'nt consider fabbing up a tougher one your self?
I didnt damage it.A previous owner cut some huge bits off it exposing the bottom corners of the radiator to fit a bullbar.
Im in the process of removing the bullbar so i can fit an new bumper with a winch in it.
Actually......they have the email thingy abelsmith@xtra.co.nz , their ad says "Parallel Imported Radiators", as an option what about one from a wrecker?, may need a clean and be ok? their phone is 04 385 0580 (Abel Smith Radiators)....
70 series prado (KZJ78) and 90 Series Prado (KZJ95)