block sleave movement

Athalus78 · Post by **Athalus78** » Sun May 29, 2005 9:40 pm

I have just taken the heads off of the p76 to get them worked and noticed that on number 7 piston the sleave is sitting about 1-2mm high than the block. Any chance I can belt it back down with a big hammer or is it a $$$$$$$$$$$$$$$ problem. The block has been bored out to 5.0 using 4.6 pistons and sleaves so I'm hoping that I don't need to resleave the whole lot.

Athalus78 · Post by **Athalus78** » Wed Jun 08, 2005 11:45 pm

Found that a big hammer and a piece of jarrah moved it back down enough so it is lower than the head gasket so it's all good.

toyking · Post by **toyking** » Thu Jun 09, 2005 7:10 am

the inner liner has moved up and youve just tapped it back down with a bit of hardwood :roll:

yeah sounds like you know what youre :lol:

doin,ha thats the best one ive heard yet

Athalus78 · Post by **Athalus78** » Thu Jun 09, 2005 11:49 pm

If you don't try you'll never know.
If it goes bang I'll let you know :lol: