Small Lazer Cutting Job

[oldblue]

Any one know where I can get these end plates made?, about 1mm thick.
Do's not need the 3 small slots.

[safari_mulisha]

what is it? i know a few in and around hamilton that could

[oldblue]

Its the end of a Cruiser electric hub Motor. This part I need for the hub convertions, thinking that I may need to sus out if they can be made.
Sometimes they are broken[ very hard , as if the have been tempered] when the arrive to be changed over.
May be 2mm thick.

[safari_mulisha]

anything can be made bro
money talks

they look simple enuff just have a flick through the yellow pages

[Rotazuk]

I used some guys in Avondale , they did lazer and water cutting , just can't remember the name . But they did have a min charge about $200 . I just ended up with about 17 of what I wanted .

Chris

[Armourguard]

Try North Shore Laser Cutting Ltd 09 912 8530 Jono from Performance Metalworks got me alot done there for me and it was half of what Laserstream in Avondale wanted

[IcedJohnno]

Kevin, you are probably looking for somewhere closer to you. I don't know of anywhere up your way, but I suspect there probably is someone there. Most good sheetmetal working places can laser cut these days.

In Chch there are quite a few, Carlton Taylor springs to mind, they are part of the Hamer Group. I am currently getting a large amount of work done thru one of their other businesses, an aluminium diecasting company.

Carlton Taylor do a lot of very accurate work for electronic assemblys, I had a look around their site a month ago.

Contact would be Jason Mangan who is their Production Engineer, jmangan@carltontaylor.co.nz or ph 03 366 9064
cheers John

[ruf_zuki]

P.C.S (Profile Cutting Services) or C & R equipment here in christchurch can do it,

[oldblue]

Did a bit of thinking and came up with a new type of dummy motor.
One that do's not need the small plate, but is held in place with a circlip.
Thank to those that offered infomation on lazer cutting firms.