sarted thinking!!!!!!!

hiriklux · Post by **hiriklux** » Wed Aug 03, 2005 9:24 pm

All right guys been pricing snorkles and a roof bar setup for my hilux somthing heavey duty being a builder well lets start with the snorkle $300 :shock:

for a crappy plastic one jesus and then the roof bars $200 :shock:

.................so i started thinking :idea:

what if i went the whole hog and made a snorkle and a roof bar setup ........ shit just make a whole roll cage with the snorkel and roof bars built in so stopped off at the tool shop on the way home to see about a pipe bender......... yep they've got one .......... f*** it lets have a go so i bought it for less than snorkle and roof bars......bargain:D

nice and shiney new.........all good so far
now need a bit of help!!!
firstly attaching roll cage at front its gonna be external so i pulled the wing off and had a bit of a look there's part of the body just infront of the door that looks like it might take the weight of a knock or two with a bit more bracing what do you guy's think??
also what size tube do you think ill get away with as i want to keep it as light as possible but strong enough??? the snorkle will be 76mmx1.6mm wall on passenger side and form part of the cage so might do same on drivers side then brace it across the body with some smaller 50 mm tube
to keep the overall weight down i thought well hey i'll make a flatdeck and dump the factory ute bed then i can get the rear of the cage onto somthing substancial at the back

anyway thought id run it by you guys before i get started any input welcomed good or bad

tomsoffroad · Post by **tomsoffroad** » Fri Aug 05, 2005 5:56 am

Shit your going to be a busy man for a while. :wink:

Once you have it sussed will you build an exo for mine too :?:

Check out this link. I don't know if you already know this or not.

http://www.pirate4x4.com/tech/bendin_tube/index.html

Post by **mike** » Fri Aug 05, 2005 10:31 pm

Nice link Tom

I've added it to the linked articles section.

Should help you with that bender hiriklux unless your a pro already :wink:

Have to catch up again sometime Tom, been awhile :oops:

You should try to come on the trip at New years, good bunch of guys who go, youd fit right in :wink:

Mike

tomsoffroad · Post by **tomsoffroad** » Sat Aug 06, 2005 7:43 am

Have to catch up again sometime Tom, been awhile You should try to come on the trip at New years, good bunch of guys who go, youd fit right in

What are you planning Mike?

Post by **mike** » Sat Aug 06, 2005 1:52 pm

http://www.offroadexpress.co.nz/modules ... pic&t=1083

hiriklux · Post by **hiriklux** » Sat Aug 06, 2005 8:05 pm

Cheers for that link tom

i did as he suggested and if i want a 90 degree bend in 3" pipe with my bender im gonna need the lenghts a mile long so its a welded snorkle

and the rest is going to have to be done in 1 1/2 and 2" pipe as this bends in shorter radiuses
cheers RIK

hosehustler · Post by **hosehustler** » Sat Aug 06, 2005 8:11 pm

Auto bend do good cheap large diameter, tight radius bends, easier to give them a call, tey're in chch city area